460589
9
Zoom out
Zoom in
Previous page
1/32
Next page
9
GB
These variations will not affect the food
products and the temperature will quickly
return to the set-point level.
When the door of the freezer’s chamber
is open for more than 2 minutes the
display will show E4 alarm and the
acoustic alarm will be activated.
Alarm codes
E2 – temperature sensor fault in the
freezer’s chamber
E4 – door is open
E5 – too high temperature inside the
freezer’s chamber
E6 – too high temperature after the
power failure
E2
The temperature sensors has been
damaged. Call technical service. The
built-in emergency program maintains
the admissible temperature until the fault
will be eliminated by the authorized
technical service.
E4
The door of the freezer’s chamber has
been opened for more than 2 minutes.
The alarm code disappears when the
door is closed.
E5
The temperature inside the freezer’s
chamber has been exceeding the set
temperature for more than 2 hours.
E6
There has been the power supply failure.
The power supply has been
disconnected from the freezer and the
temperature inside the freezer’s
chamber is too high.
Interrupting an alarm
The acoustic alarm can always be
interrupted by opening the door and/or
pressing any push-button.
The alarm code E3 - E6 can be cancelled by
pressing for 7-8 seconds at the same time
the push-buttons (7) and (8).
The exception: in case of the alarm E1 it
is possible to cancel the alarm only after
replacing damaged sensors.
In case the display shows symbols E5 or
E6, it is possible to monitor the maximum
temperature recorded by the control
system by pressing the buttons 9 and/or
10. If the alarm is caused by a more
permanent defect the alarm code will
appear again but without the acoustic alarm.
In such cases please contact Gram Service
Center.
Display brightness adjustment
By pressing and holding the pushbutton
(9) and
- pressing at the same time the
pushbutton (7), the display
brightness increases,
- pressing at the same time the
pushbutton
(8), the display brightness
decreases.
When adjusting the display brightness,
the display shows the following
indications:
1.8 – minimum brightness
2.8 – medium brightness
3.8 – maximum brightness
(manufacturer’s setting).
Alarms
Normal use of the freezer may cause
different situations leading to interruption
of various functions and unstable
operation of the entire equipment as a
consequence. These interruptions are
shown on the display as the alarm code
(an E followed by a number) and
signalled by the acoustic alarm.
In case there will be several faults the
alarm codes shall be displayed in turn.
t t
t t
t
ss
ss
s
ss
ss
s
t t
t t
t
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gram FS 290 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gram FS 290 in the language / languages: English, Dutch as an attachment in your email.

The manual is 0,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info