460585

Gram FS 170-II Manual

20
Zoom out
Zoom in
Previous page
1/32
Next page
20
WARNING
This freezer contains isobutane R 600a, a am-
mable gas. During transport and when setting up it
is essential to avoid damaging the freezing circuit.
If damage does occur, do not use a naked ame
anywhere near the appliance and make sure the
room is well aired. A damaged unit must not be
connected to mains voltage. If you are in doubt,
please contact your supplier.
The surface on which the appliance is placed
must be plane. Do not use a frame or similar.
Never place the freezer close to sources of heat
such as cookers or radiators, and avoid placing it
in direct sunlight.
It is important that the appliance stands completely
level and that there is good air circulation over,
under and around it. The appliance can be adjusted
by turning the two small feet at the front.
Fit the two distance pieces to the condenser on
the rear of the cabinet before pushing the
fridge/freezer against the wall.
Do not use fenders with steel condenser
trays.
The smallest models with table top are suitable for
building in under a worktop or in continuation of a
worktop if the kitchen elements have a standard
height of 85 cm. Before tting, attach the ventilation
grille supplied with the freezer.
1
Congratulations on your
new freezer
Setting up
and building in
Please read the sections on setting up and build-
ing in, starting up and electrical connection before
using your freezer.
It is also advisable to clean the cabinet interior with
lukewarm water containing a little mild detergent.
Surfaces should then be dried thoroughly with a
soft cloth before placing items in the cabinet. As
these instructions apply to several refrigerator
models, the equipment may vary from model to
model.
On receipt, check to ensure that the freezer has not
become damaged in transport. Transport damage
should be reported to the local supplier before the
freezer is put to use.
WARNING
Old refrigerators and freezers are often tted with
complicated latches that can only be opened from
the outside. If you have an old appliance like this
stored away somewhere, or if you scrap it (through
a bulk waste disposal system for example) remem-
ber to destroy the lock rst to prevent children
from being exposed to danger by getting locked
inside the cabinet.
Note! Please observe the environmental rules on
disposal. See section “Disposal”.
Illustrations are found at the back of the instruction
booklet to enable you to follow text and pictures
at the same time.
For safety and operational reasons, do not set up
the freezer outdoors.
The appliance should be placed in a dry room.
It is designed for temperature class SN in ac-
cordance with European standard EN 153. This
means that it will run best at a room temperature
of +10°C to +32°C.
GB
2
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gram FS 170-II at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gram FS 170-II in the language / languages: English, Dutch, Danish, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 0,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info