Manual Gram FS 122-02 (page 21 of 32) (English, Dutch, Danish, Swedish, Norwegian, Finnish)

460586

Zoom out

Zoom in

1/32

If two freezers or a freezer and a refrigerator are

placed side by side, there must be at least 2 cm

clearance between them.

If the appliance is not built in but positioned with

its door hinge side against a wall, there should be

at least 5 cm between the appliance and the wall

in order to allow the door to open easily.

The freezer must not be laid horizontally while

being transported or moved. If the appliance has

been tilted more than 40°, the power supply must

not be connected until the appliance has stood

upright for at least two hours.

The appliance is intended for connection to alter-

nating current. The connection values for voltage

(V) and frequency (Hz) are given on the nameplate

in the cabinet.

Power must be connected via a wall socket with

switch. The wall socket should be easily acces-

sible.

All earthing requirements stipulated by the local

electricity authority must be observed. The appli-

ance plug and wall socket should then give correct

earthing. If in doubt, contact your local supplier or

an authorised electrician.

WARNING

The exible cord (mains lead) tted to this appliance

has three cores for use with a 3-pin 13-amp or 3-pin

15-amp plug. If a BS 1363 (13-amp) fused plug is

used, it should be tted with a 13-amp fuse.

IMPORTANT

The cores in this mains lead are coloured in ac-

cordance with the following code:

GREEN-AND-YELLOW: EARTH

BLUE: NEUTRAL

BROWN: LIVE

These colours might not correspond with the colour

markings identifying the terminals in your plug.

Proceed as follows:

Connect the GREEN-AND-YELLOW core to the

plug terminal marked “E” or by an earth symbol, or

coloured GREEN or GREEN-AND-YELLOW. Con-

nect the BLUE core to the plug terminal marked “N”

or coloured BLACK. Connect the BROWN core to

the plug terminal marked “L” or coloured RED.

Electrical connection

You can change the

door from right-hinged

to left-hinged or vice

versa yourself

Illustration shows how easy it is to change the

door from right-hinged to left-hinged - or vice versa.

Take off the table top by removing two screws at the

front of the cabinet and three at the back.

Lay the appliance on its back with the door up.

Remove the door handle.

Unscrew the adjusting screws and take the

brackets off.

Remove the door.

Take off the upper hinge bracket and ret it on the

opposite side of the cabinet.

Replace the door.

Move the pin on the hinge bracket to the other

threaded hole before retting the hinge brackets

on the opposite lower side of the cabinet.

Remember to replace the shim washer on the

hinge pin.

Ret the adjusting screws and the door handle.

Replace the table top.

Specically for Fresh line models 5A

Switch the cabinet off by turning the thermostat

knob to ”0”. Empty the cabinet and begin by

removing the door handle. Tilt the cabinet 40°

in order to gain access to the lowest hinge.

Remove the adjustable feet. Remove the three

screws holding the lowest bracket in place using

a Phillips screwdriver. (1). Remove the door

and unscrew the three screws from the bracket

on the base on the cabinet (2).

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Gram FS 122-02 in the language / languages: English, Dutch, Danish, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 0,65 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Gram FS 122-02 Manual

Product: