725322
67
Zoom out
Zoom in
Previous page
1/80
Next page
6 Vehicle
Information
67
Lap/Shoulder Seat Belt Installation
How to Lock Your Lap/Shoulder Vehicle Seat Belt
Sliding Latch Plate
and Switchable
Retractor
A latch plate that slides
freely on the belt webbing
and cannot, by itself, hold
the belt snug around a car
seat.
When installing the car
seat, route the vehicle seat
belt through the proper
belt path and buckle it in.
Slowly pull the shoulder
belt all the way out
to switch it to locking
mode. Then, as you pull
the vehicle seat belt tight,
feed all the slack back into
the retractor.
Grab the sides of the base
or seat at the belt path and
slide side to side and front
to back. The base or seat
should not move more
than 1” (2.5 cm).
Note: With the vehicle seat belt in
this locking mode, all the tension
is upwards in the shoulder belt.
This may start to tilt your car seat
sideways when rear-facing. If this
happens, use a locking clip instead of
switching the retractor. See Sliding
Latch Plate and ELR Retractor.
Note: When using the base, you do
not need to switch the retractor. The
lock-off locks the seat belt.
67


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Graco SnugRide- SnugRide 30 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Graco SnugRide- SnugRide 30 in the language / languages: English as an attachment in your email.

The manual is 8,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info