505086

Graco Infant SafeSeat Manual

37
Zoom out
Zoom in
Previous page
1/88
Next page
37
1. For ease of installation, extend
LATCH to its maximum length
and remove from storage bars.
2. Position base in vehicle seat as
shown.
3. Make sure LATCH is through
vehicle/LATCH belt path normally
used for vehicle seat belt.
.
Belt must lay flat and not be twisted.
4. Hook Connectors to vehicle lower
anchors. Pull firmly on Connectors to
be sure they are attached .
5. Tighten LATCH by pushing down
hard on base and pulling the
adjustment belt .
6. NEVER put two LATCH connectors
on one vehicle LATCH anchor unless
specifically allowed by the vehicle
manufacturer
.
7. Test infant restraint for secure
installation as described in infant
restraint
“Final Safety Check” page.40
.
8. Check that the LATCH stays tight
and does not slip from the tightened
position. If it does not stay tight, try another
seating position or contact Graco at 1-800-345-4109.
7.3 Using LATCH to install Base
… 37 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Graco Infant SafeSeat at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Graco Infant SafeSeat in the language / languages: English, Spanish as an attachment in your email.

The manual is 2,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info