768370

Graco Bumper Jumper Manual

4
Zoom out
Zoom in
Previous page
1/27
Next page
5 6
EN WARNING
Complies to EN 14036:2003
PLEASE SAVE OWNER’S MANUAL FOR
FUTURE USE.
Adult assembly required.
NEVER LEAVE THE CHILD UNATTENDED.
Always keep your child in view.
DO NOT USE THE BABY BOUNCER AS A
SWING.
ENSURE BABY BOUNCER IS POSITIONED
CENTRALLY IN A DOOR FRAME.
DO NOT use if child can not hold his
head upright or child weighs over 12
kg (approximately 24 months) or if child
becomes too active to safely play in the
baby bouncer.
AVOID STRANGULATION. DO NOT place
items with a string around your child’s
neck, suspend strings from this product,
or attach strings to toys.
Only use component parts from
manufacturers for this product.
Make sure that the door cannot close on
the baby bouncer.
A recommendation of a time limit of a
maximum of 20 min for the child to be in
the baby bouncer.
It’s very dangerous for other children to
play near the baby bouncer.
DO NOT leave baby bouncer in doorway
when not in use. Store out of children’s
reach.
DO NOT use near stairs.
USE ONLY in recommended doorways.
DO NOT use baby bouncer when height
cannot be adjusted so that only the front
of your child’s foot touches the floor.
Ensure that the child is correctly and
safely positioned in the seat of the baby
bouncer.
DISCONTINUE USING YOUR BABY
BOUNCER should it become damaged or
broken.
DO NOT use when your child can walk
unaided.
DO NOT use if the tray of your baby
bouncer is lower than your baby’s waist
level when your child stands in the baby
bouncer.
USE BABY BOUNCER when you have a
door frame which will properly support
the baby bouncer.
USE BABY BOUNCER when your baby can
sit upright unaided and hold his head
upright, and can support most of his body
weight with his legs.
USE BABY BOUNCER when you are able to
watch your baby at all times while playing
in the baby bouncer.
CARE & MAINTENANCE
TO WASH SEAT: Machine wash in cold
water on delicate cycle and drip-dry. NO
BLEACH.
TO CLEAN BABY BOUNCER, use only
household soap and warm water. NO
BLEACH or detergent.
FROM TIME TO TIME CHECK YOUR BABY
BOUNCER for worn parts, torn material
or stitching. Replace the parts as needed.
Use only Graco replacement parts.
ATTACHING SEAT
1. Insert seat with pattern side as shown.
2. Tuck seat into tray.
3. Turn tray upside down. BE SURE all 6
rings are hooked onto the pegs.
4. Test seat assembly by pushing own
hard on seat.
Hanging the baby bouncer
1. Wall requirements for hanging baby
bouncer:
a. ½” (1.25 cm) minimum flat surface
at top of molding.
b. Molding
c. Wall thickness 3” (7.6 cm) to 6½”
(16.5 cm)
2. Check that clamp is secure on door
frame by pulling firmly down on the
clamp cover. If molding moves, repair
it before using the baby bouncer.
Adjusting the baby bouncer
1. only the front of your baby’s foot
touches the floor.
2. At proper height
3. Too high
4. Too low
5. If baby bouncer is to close to floor:
a. Pull on small loop as shown until
the sewn end of the loop passes
through the slot in the adjustment
buckle.
b. Continue to pull out the small loop
as shown until the strap is proper
length.
Toys (on certain models)
Fasten hook and loop tab from toys
around the loops as shown.
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Graco Bumper Jumper at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Graco Bumper Jumper in the language / languages: All languages as an attachment in your email.

The manual is 0,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info