768362
18
Zoom out
Zoom in
Previous page
1/84
Next page
18
12 13
34
35
European Standard
Your booster seat has been approved to European Standard ECE R44.04
Universal Group 2,3 15-36kg
An approved number is attached to the seat shell and must not be removed.
belts, approved to ECE Regulation No.16 or other equivalent standards.
GB
GB
Always keep this Owner’s Manual with the booster seat. Provisions are made
on the bottom of the seat shell.
WARNING
DO NOT INSTALL OR USE THIS BOOSTER SEAT UNTIL YOU
READ AND UNDERSTAND THE INSTRUCTIONS IN THIS
MANUAL AND IN YOUR VEHICLE OWNER’S MANUAL.
IT IS MOST IMPORTANT that the booster seat is correctly routed
with the lap portion of the belt across the red belt guides under the
armrests and the diagonal belt through the red shoulder belt guides.
Ensure the belt webbing is not twisted.
DO TAKE CARE to locate and install the booster seat so that it is not
liable to become trapped by a moveable seat or in a door of the vehicle.
FAILURE TO PROPERLY USE THIS BOOSTER SEAT
INCREASES THE RISK OF SERIOUS INJURY OR DEATH IN A
SHARP TURN, SUDDEN STOP OR CRASH.
DO NOT use alternative load-bearing points not shown in these
instructions.
NEVER LEAVE YOUR CHILD UNATTENDED.
GB
GB
e vehicle seat belt, holding the child restraint to the vehicle,
should be tight.
EN
18 19
lap belt portion MUST pass under the armrests and
be positioned low on the hips.
Belt MUST NOT be twisted.
If the belt lays across child’s neck, head or face, readjust head support
height. Follow instructions, “Adjusting the Head Support” .
Adjusting the Head Support
BEFORE adjusting the head support height, have your child lean
forward slightly.
Squeeze the red adjustment button on top of seat and pull back support up
until it snaps into one of the 6 height positions.
To lower, squeeze red adjustment button and push down.
CHECK to make sure it is securely snapped into one of the 6 height
positions by pulling up on head support.
Cupholders
To avoid burns, NEVER put hot liquids in your cupholders.
Cupholders are included on both sides of the seat.
To Remove Seat Cover
Remove elastic loops and hooks from seat as shown.
Machine wash cover in cold water on delicate cycle and
drip-dry. DO NOT USE BLEACH.
To put the seat cover back on, reverse preceding instructions.
24
25
26
27
28
29
30
31
32
33
Attach connectors to vehicle lower anchors.
NEVER put two connectors on one vehicle anchor.
retain the restraint during an impact, when it is not being used.
To remove booster, lift release levers on sides of booster and pull slightly
away from seat.
Push connector in, lift connector up and pull out (away from anchor point).
Repeat on other connector.
34
35
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Graco Affix at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Graco Affix in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Turkish, Spanish as an attachment in your email.

The manual is 3,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info