590657
6
Zoom out
Zoom in
Previous page
1/14
Next page
6 GMC-I Messtechnik GmbH
3 How to test insulation meters
The ISO-Kalibrator 1 permits testing of insulation meters hav-
ing a nominal voltage up to 1000 V. The test range extends
from 100 k to 100 M.
Caution!
!
To assure the safety of both the user and the unit,
do not on any account apply a test voltage of more
than 1000 V to ground to the sockets of the unit.
The load limits of the test resistors given in section
5, Specifications, must on no account be exceeded.
To test your insulation meter, proceed as follows:
1) Connect the two probes of your insulation meter to the test
sockets B1 and B3 (blue sockets).
2) Select the desired test resistor with the rotary knob on your
ISO-Kalibrator 1.
3) Select the desired test voltage and the desired measuring
range on your insulation meter according to the operating
instructions of your insulation meter.
4) Perform the insulation measurement. Wait for your meter to
stabilize – particularly in the case of higher resistance val-
ues, 10 M and higher.
5) Read the measured value on your insulation meter.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gossen Metrawatt ISO-KALIBRATOR 1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gossen Metrawatt ISO-KALIBRATOR 1 in the language / languages: English as an attachment in your email.

The manual is 0,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info