571661
18
Zoom out
Zoom in
Previous page
1/39
Next page
GOSSEN Foto- und Lichtmesstechnik GmbH 18
6.2.2 Flash Light Reading Analysis
Use the ring controller ...
to select synchronization
speed and analyze flash
component.
Flash component is
displayed as a percentage.
i
Please note that some flash units must first be triggered once when set to lower power levels.
Stored power is still at the higher level, resulting in erroneous measurements.
i
The ratio between flash and ambient light can be influenced by changing synchronization
speed. This is interesting for brightening up the image with flash, or when ambient light is not
desired.
!
Warning in Case of User Error
A warning may be caused by any of the following conditions.
General:
Measurement has been performed outside of the measuring
range. There are no usable results EV display: OVR. Flash
was too bright or too weak. Change conditions and measure
again.
See also Technical Data Measuring Range on page 31.
NonCord
Time out Flash was not triggered during “flash standby time”.
Break Flash standby time was stopped by pressing the
measurement key.
Cord:
The synchronizing cable was not connected.
The synchronizing cable is defective and must be replaced.
Radio:
No flash regardless of setting:
Check menu settings.
RF module - RF channel on page 26.
Flash is only triggered in the “All” setting.
The menu settings are correct please select the right
group.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gossen DIGISKY at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gossen DIGISKY in the language / languages: English as an attachment in your email.

The manual is 2,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Gossen DIGISKY

Gossen DIGISKY User Manual - German - 39 pages

Gossen DIGISKY User Manual - Dutch - 35 pages

Gossen DIGISKY User Manual - French - 39 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info