512796
3
Zoom out
Zoom in
Previous page
1/17
Next page
Instructions for Use
20
Important
Before putting the machine into use, don't
forget to remove the transport brackets.
Switching on a blocked machine may damage
the machine. Our guarantee does not cover
such damage.
Before switching the machine on, check that
the transport brackets has been removed.
Don't place the appliance in a room where the
temperature may fall bellow 0°C, causing
individual parts of the machine to freeze and
become damaged (hose may crack).
The appliance should stand firmly and
horizontally on a solid base (a machine
standing on an uneven floor is very likely to
vibrate during the spinning cycle).
Always consider the instructions for correct
placing and installation of the machine to the
mains and water supply. This will help you
avoid accidents and protect your machine
against damage.
The appliance is to be connected to the water
mains using new
hose-sets and that old hose-
sets should not be reused.
The appliance my not be built-in under the
kitchen worktop in a row of cabinets,
because the use of the appliance without
the top cover is not allowed for safety
reasons. Likewise, the removal of the rear
panel and the bottom of the appliance are
also not allowed.
The appliance should be positioned in such way
to provide normal ventilation.
The end of the outlet hose should not be
immersed in the discharge water (the machine
may pump the discharge water back).
During the washing cycle, the door of the
machine cannot be opened. It can only be
opened 2 minutes after washing is finished.
The glass door gets very hot during washing, so
take care of children.
Use only washing powder and other agents
specially designed for machine washing.
We do not take any responsibility for damage
caused by the improper use of bleaching or
colouring agents (coloured gasket and other
plastic parts).
Lime dissolving agents contain acid, so only
use those containing rust-protection agents.
Always consider the manufacturer's
instructions. When you have finished removing
lime deposit, run a few rinse cycles to make
sure that the acid is thoroughly rinsed. Even
traces of acid can cause substantial damage to
component parts.
Never use washing agents containing solvents -
individual component parts may be damaged or
toxic gases may be produced. There is also a
risk of ignition or explosion.
When washing is finished, remember to close
the tap.
Your washing machine can only be transported
with transport brackets. It is usually enough to
use only one of the rods, that is the upper one.
It is much easier to insert the rod if you remove
the top cover. Before doing anything, however,
don't forget to disconnect the machine from the
power supply.
Data plate with essential information on the
appliance is fitted above the opening for laundry
insertion under the door frame.
Noise level
Noise level of your new washing machine when
spinning can differ very much from the previous
one. This is due to the drive of up-to-date motor
with electronic controlled universal motor, which
enables the following:
- gentle tumbling of laundry with soft drive
- better distribution of laundry in the drum during
the spinning cycle
- stability of the machine during the spinning
cycle
(UKS) - Unbalance Control System
This washing machine is equipped with the UKS -
unbalanced control system. This means that the
spinning starts smoothly, even in case of smaller
wash loads or inadequate loads.
In case of unfavorable distribution of laundry in
the drum, this is sensed by the UKS system and
the automatic re-distribution of the laundry follows
immediately, then only spinning starts.
In case the re-distribution of the laundry is not
successful (only one large piece in the drum), the
UKS system reduces the spinning speed (r.p.m.),
to prevent damages to the washing machine.
The symbol on the product or on its
packaging indicates that this product
may not be treated as household
waste. Instead it shall be handed over
to the applicable collection point for the
recycling of electrical and electronic
equipment. By ensuring this product is
disposed of correctly, you will help prevent
potential negative consequences for the
environment and human health, which could
otherwise be caused by inappropriate waste
handling of thisproduct. For more detailed
information about recycling of this product,
please contact your local city office, your
household waste disposal service or the shop
where you purchased the product.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje WA1042 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje WA1042 in the language / languages: English as an attachment in your email.

The manual is 0,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info