Manual Gorenje WA1022 (page 3 of 17) (English)

512795

Zoom out

Zoom in

1/17

Instructions for Use

Important

Before putting the machine into use, don't

forget to remove the transport brackets.

Switching on a blocked machine may damage

the machine. Our guarantee does not cover

such damage.

• Before switching the machine on, check that

the transport brackets has been removed.

• Don't place the appliance in a room where the

temperature may fall bellow 0°C, causing

individual parts of the machine to freeze and

become damaged (hose may crack).

• The appliance should stand firmly and

horizontally on a solid base (a machine

standing on an uneven floor is very likely to

vibrate during the spinning cycle).

• Always consider the instructions for correct

placing and installation of the machine to the

mains and water supply. This will help you

avoid accidents and protect your machine

against damage.

• The appliance is to be connected to the water

mains using new

hose-sets and that old hose-

sets should not be reused.

• The appliance my not be built-in under the

kitchen worktop in a row of cabinets,

because the use of the appliance without

the top cover is not allowed for safety

reasons. Likewise, the removal of the rear

panel and the bottom of the appliance are

also not allowed.

• The appliance should be positioned in such way

to provide normal ventilation.

• The end of the outlet hose should not be

immersed in the discharge water (the machine

may pump the discharge water back).

• During the washing cycle, the door of the

machine cannot be opened. It can only be

opened 2 minutes after washing is finished.

• The glass door gets very hot during washing, so

take care of children.

• Use only washing powder and other agents

specially designed for machine washing.

• We do not take any responsibility for damage

caused by the improper use of bleaching or

colouring agents (coloured gasket and other

plastic parts).

• Lime dissolving agents contain acid, so only

use those containing rust-protection agents.

Always consider the manufacturer's

instructions. When you have finished removing

lime deposit, run a few rinse cycles to make

sure that the acid is thoroughly rinsed. Even

traces of acid can cause substantial damage to

component parts.

• Never use washing agents containing solvents -

individual component parts may be damaged or

toxic gases may be produced. There is also a

risk of ignition or explosion.

• When washing is finished, remember to close

the tap.

• Your washing machine can only be transported

with transport brackets. It is usually enough to

use only one of the rods, that is the upper one.

It is much easier to insert the rod if you remove

the top cover. Before doing anything, however,

don't forget to disconnect the machine from the

power supply.

• Data plate with essential information on the

appliance is fitted above the opening for laundry

insertion under the door frame.

Noise level

Noise level of your new washing machine when

spinning can differ very much from the previous

one. This is due to the drive of up-to-date motor

with electronic controlled universal motor, which

enables the following:

- gentle tumbling of laundry with soft drive

- better distribution of laundry in the drum during

the spinning cycle

- stability of the machine during the spinning

cycle

(UKS) - Unbalance Control System

This washing machine is equipped with the UKS -

unbalanced control system. This means that the

spinning starts smoothly, even in case of smaller

wash loads or inadequate loads.

In case of unfavorable distribution of laundry in

the drum, this is sensed by the UKS system and

the automatic re-distribution of the laundry follows

immediately, then only spinning starts.

In case the re-distribution of the laundry is not

successful (only one large piece in the drum), the

UKS system reduces the spinning speed (r.p.m.),

to prevent damages to the washing machine.

The symbol on the product or on its

packaging indicates that this product

may not be treated as household

waste. Instead it shall be handed over

to the applicable collection point for the

recycling of electrical and electronic

equipment. By ensuring this product is

disposed of correctly, you will help prevent

potential negative consequences for the

environment and human health, which could

otherwise be caused by inappropriate waste

handling of thisproduct. For more detailed

information about recycling of this product,

please contact your local city office, your

household waste disposal service or the shop

where you purchased the product.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje WA1022 in the language / languages: English as an attachment in your email.

The manual is 0,84 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Gorenje WA1022 Manual

Product: