729246
17
Zoom out
Zoom in
Previous page
1/28
Next page
17
Vacuum cleaner assembling
Always remove the plug from the power supply
before fitting or removing accessories. Before
putting the appliance into service, please check if
all filters are inserted correctly.
ASSEMBLY OF THE SUCTION HOSE
Insert the flexible suction hose into the
connection opening at the top of the
housing until you can feel it lock.
HOSE REMOVING
To remove flexible hose from the vacuum
cleaner, press the buttons situated on the
flexible hose base, then pull to remove it
from the attachment point.
ROLLING THE CABLE OUT AND UP
Pull out the cable to such a length that easy
working is ensured. Now connect the
appliance to the main supply. Press the
switch to activate the automatic rewinder
and hold on the mains plug for safety
reason.
FITTING TUBE AND ACCESSORIES
- Extend the tube to the desired length by
pressing on button.
- Insert a flexible hose into a tube.
- Fit a nozzle to tube:
- Floor brush is intended for cleaning
bare floor and floor coverings.
- 3 pcs. set of nozzles are appropriate
for cleaning corners and other small,
inaccessible places.
- Parquet brush is appropriate for
cleaning sensitive floors and flat
surfaces such as parquet, laminate,
tile, etc. Bristles for efficient cleaning
are at the bottom and over the entire
length so you cannot damage your
floor.
Instruction for use
Before using the appliance, unwind a
sufficient length of cord and insert the plug
into the power supply.
Press the On/Off button to switch the unit
on. To stop it press the On/Off button again.
You can adjust the air flow using the air flow
regulator on the flexible hose:
- decrease power for cleaning curtains,
books, furniture, etc.
- increase power for cleaning bare floor.
To rewind the cord, press the rewind button and
guide the cord with hand to ensure that it does
not whip causing damage.
Maintenance
1. Changing of the dust bag
Always operate the cleaner with dust bag
installed.
If you forget to attach the dust bag or attach
it in the wrong manner, the dust cover may
not close completely.
1. After removing the flexible tube, open the
front cover.
2. Rotate the support of the bag to the correct
position.
3. Remove the dust bag.
4. Replace the bag when it is full of dirt and
put in a new one.
5. Close the cover by passing down unitil it is
locked.
2. Cleaning filter
1. Open the cover for HEPA filter.
2. When open the cover for HEPA filter, use
your two fingers pulling ouch for HEPA,
then pulling HEPA up.
3. Take the HEPA out and change a clean
one.
4. Close the cover for HEPA filter.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje VC2322GPLBK at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje VC2322GPLBK in the language / languages: English as an attachment in your email.

The manual is 0,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info