603637
13
Zoom out
Zoom in
Previous page
1/40
Next page
13
consumption pattern for seven consecutive days. After that, the recorded pattern starts to
be used automatically and the heater prepares the hot water based on the
measurements from the previous week. At the same time, the heater continues to record
the consumption. If the pattern differs from the previous week in terms of time or volume,
the newly recorded pattern is used the following week.
The water temperature in the "ECO
S
" mode is kept between 40 °C and 75 °C. When no
consumption is anticipated (standby temperature), the water is maintained at 40 °C.
If, during recording, there was a power failure or the heater was switched off, the
recording is not valid.
The "ECO
S
" mode can be turned off by twisting the control knob to any other position.
Anti-legionella function
The function is factory set. After connecting to the power supply or after eliminating an
error, the anti-legionella function is switched on after 3 days.
When the heater is switched on and the temperature of the water in the heater is above 62
°C continuously for 15 minutes, the countdown is finished. As soon as the temperature falls
below 62 °C, a 30-day countdown begins again. If within 30 days the heater does not reach
62 °C, the anti-legionella function is switched on and the heater heats the water to the
temperature of 62 °C for 15 minutes.
If the heater is not switched on or connected to the power supply and the 30-day period
expires, the anti-legionella function does not switch on until the heater is turned on.
If the anti-legionella function is in operation and the user switches off the heater, the
function is interrupted and a new 30-day countdown begins.
If the user lowers the set temperature during the operation of the anti-legionella functions,
the function is interrupted and a new 30-day countdown begins.
Error indication
In case of an error or warning on the heater, red and green light start blinking to indicate an
error according to the table below.
STATUS
RED light
GREEN light
Normal operation
Heater switched off
/ /
Heater switched on, no error, heater not
operating
/ /
Heater switched on, no error, heater
operating
GLOWING
/
Operation in ECO
S
mode
Heater switched on, no error, heater not
operating
/
GLOWING
Heater switched on, no error, heater
operating
GLOWING
GLOWING
ERRORS (Call the service)
Heater switched on, temp. sensor error
(sensor 1 or sensor 2 in short circuit or open
circuit, temp. difference error)
BLINKING
BLINKING
Heater switched on, heater warning
BLINKING
BLINKING
EN
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje TGR 30-120 SM -UNI at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje TGR 30-120 SM -UNI in the language / languages: English as an attachment in your email.

The manual is 1,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info