Manual Gorenje rf 4248 w (page 10 of 10) (English)

358020

Zoom out

Zoom in

1/10

Instructions for Use22

• The reason may be inadequate ventilation of

the compressor and condenser (assure

adequate air circulation and wipe off the

condenser);

• Continuous operation button activated (see

section Freezing of Food).

Ice Formation on the Inner Rear Wall

As long as the defrost water runs to the

channel and through the outlet to the drain pan

on the compressor, automatic defrosting of the

appliance is assured. In case the ice formation

on the inner back wall is increased (3-5 mm),

ice should be manually defrosted. Set the

thermostat knob to STOP (0) position and

leave the door open. Never use electric

devices for defrosting and do not scrape the

ice or frost layer with sharp objects. After

completed defrosting, turn the knob to desired

position and close the refrigerator door. The

cause of increased ice formation may be one

of the following:

− the door does not seal well (clean the

gasket if it is contaminated, or replace it

if it is damaged);

− the door was frequently opened or it

was left opened for too long;

− the food stored in the refrigerator was

warm;

− the food or dish is touching the inner

back wall.

Water is Leaking From the Refrigerator

In case the discharge water outlet is clogged,

or the defrost water drips over the channel,

water leaks from the refrigerator.

• Clean the clogged opening, for example with

a plastic straw.

• Manually defrost the increased ice layer.

See "Ice Formation on the Inner Back Wall".

The Freezer Door is Hard to Open

If you want to open the door that has just or

recently been closed, you may find it hard to

open. The reason why this happens is, that

when you open the door, warm air gets into the

appliance and when it is getting cool, the

underpressure seals the door. After few

minutes (1-3), the door can easily be opened.

Noise

Cooling in refrigerating-freezing appliances is

enabled by the cooling system with

compressor, which produces noise. How noisy

the appliance is depends on where it is placed,

how it is used and how old the appliance is.

• During the operation of the compressor the

noise of liquid is heard and when the

compressor is not operating, the refrigerant

flow is heard. This is a normal condition and

it has no influence whatsoever on the

lifetime of the appliance.

• After starting the appliance, the operation

of the compressor and the refrigerant flow

may be louder, which does not mean that

something is wrong with the appliance and it

has no influence on the lifetime of the

appliance. Gradually the noise is reduced.

• Sometimes unusual and stronger noise is

heard, which is rather unusual for the

appliance. This noise is often a

consequence of inadequate placing.

− The appliance shall be placed and

levelled firmly on solid base.

− It should not touch the wall or kitchen

units standing next to it.

− Check the accesories in the interior of

the appliance, they should be placed

correctly in their positions; also check

the bottles, tins and other vessels that

might touch each other and rattle.

Bulb Replacement

Before replacing the light bulb, disconnect the

appliance form the power supply. Press the

cover at the rear side (in the arrow 1 direction)

and remove the plastic cover (in the arrow 2

direction). Replace the bulb with a new one

(E14, max. 15 W). Don't forget: the old bulb

does not belong to organic waste.

Light bulb is consuming good therefore our

in-guarantee service does not relate to it.

WE RESERVE THE RIGHT TO ALTER THE SPECIFICATIONS WITH NO

INFLUENCE ON THE OPERATION OF THE APPLIANCE.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje rf 4248 w in the language / languages: English as an attachment in your email.

The manual is 0,42 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Gorenje rf 4248 w Manual

Product: