728424
10
Zoom out
Zoom in
Previous page
1/11
Next page
Instructions for Use 23
Trouble-Shooting Guide
During the service, you can come across some
troubles that in most cases result from
improper handling of the appliance and can
easy be eliminated.
The Appliance Fails to Operate After
connecting to the Mains Supply
Check the supply in the outlet socket and
make sure the appliance is switched on
(thermostat in operating position).
Continuous Operation of the Refrigerating
System
the door was frequently opened or it was left
opened for too long;
the door is not properly closed (the door may
sag, the gasket may be polluted or
damaged);
perhaps you have overloaded the appliance
with fresh foods;
The reason may be inadequate ventilation of
the compressor and condenser (assure
adequate air circulation and wipe off the
condenser);
Ice Formation on the Inner Rear Wall
As long as the defrost water runs to the
channel and through the opening to the drain
pan on the compressor, automatic defrosting of
the appliance is assured. In case the ice
formation on the inner back wall is increased
(3-5 mm), ice should be manually defrosted.
Set the thermostat knob to STOP position and
leave the door open. Never use electric
devices for defrosting and do not scrape the
ice or frost layer with sharp objects.
After completed defrosting, turn the knob to
desired position and close the refrigerator door.
The cause of increased ice formation may be
one of the following:
the door does not seal well (clean the
gasket if it is contaminated, or replace it
if it is damaged);
the door was frequently opened or it
was left opened for too long;
the food stored in the refrigerator was
warm;
the food or dish is touching the inner
back wall.
Water is Leaking From the Refrigerator
In case the discharge water outlet is clogged,
or the defrost water drips over the channel,
water leaks from the refrigerator.
Clean the clogged opening, for example with
a plastic straw.
Manually defrost the increased ice layer.
See Ice Formation on the Inner Back Wall.
Noise
Cooling in refrigerating-freezing appliances is
enabled by the refrigerating system with
compressor, which produces noise. How noisy
the appliance is depends on where it is placed,
how it is used and how old the appliance is.
During the operation of the compressor the
noise of liquid is heard and when the
compressor is not operating, the refrigerant
flow is heard. This is a normal condition and
it has no influence whatsoever on the
lifetime of the appliance.
After starting the appliance, the operation
of the compressor and the refrigerant flow
may be louder, which does not mean that
something is wrong with the appliance and it
has no influence on the lifetime of the
appliance. Gradually the noise is reduced.
Sometimes unusual and stronger noise is
heard, which is rather unusual for the
appliance. This noise is often a
consequence of inadequate placing.
The appliance shall be placed and
levelled firmly on solid base.
It should not touch the wall or kitchen
units standing next to it.
Check the accesories in the interior of
the appliance, they should be placed
correctly in their positions; also check
the bottles, tins and other vessels that
might touch each other and rattle.
Bulb Replacement
Before replacing the light bulb, disconnect the
appliance form the power supply.
Insert the screw driver into the bulb cover
opening on the lower side and with slight push
downward remove the cover. Replace the old
bulb with a new one – halogenous or standard
(E 14, max. 25 W - Osram Halolux, Philips
H.E.) and fit back the cover.
Don't forget: the old bulb does not belong to
organic waste.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje RBI4092AW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje RBI4092AW in the language / languages: English as an attachment in your email.

The manual is 0,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info