After using the appliance, if it is left
unattended or if the appliance is faulty,
ALWAYS disconnect the power lead
from the mains socket. Do NOT pull
the power lead over sharp edges.
To prevent injury, any repairs such as
replacing a damaged power lead,
should only be carried out by customer
service.
Worn-out appliances must be made
unsuitable for further use.
Never connect this appliance to an
external timer switch or remote control
system in order to avoid a hazardous
situation.
The wall socket must be accessible
and must be earthed according to
technical specification.
Noise level: Lc < 75 dB(A)
This appliance is marked according to the
European directive 2012/19/EU on Waste
Electrical and Electronic Equipment
(WEEE). This guideline is the frame of a
European-wide validity of return and
recycling on Waste Electrical and
Electronic Equipment.
Operating the appliance
Before using the appliance for the first time, clean it
thoroughly.
Preparation
• Place the appliance on a flat, clean surface.
• Insert the power lead plug into the mains socket.
• Attach the carriage and rest end holder to the
appliance housing.
• Set the desired slicing thickness (0 to 15 mm).
• Low adjustment range provides narrow slicing (e.
g. for salami, ham).
Switching the appliance
ON/OFF
Risk of injury by the sharp blade
When the appliance is switched OFF, the blade
continues rotating for some time. Do not touch it with
your hands!
WARNING!
The motor may overheat
After a maximum of 5 minutes of continuous use,
switch OFF the appliance and allow it to cool down.
Slicing
• Gently press the food to be sliced against the
stop plate and slowly slide it against the moving
blade.
Do not operate the appliance without the carriage
and rest holder unless absolutely necessary due to
the shape and size of the food.
After using the appliance
• Set the slicing thickness to »P«.
• After slicing greasy food (e.g. meat, sausages,
cheese):
• The appliance and especially the blade should be
cleaned immediately; (see section "Cleaning").
Cleaning
Risk of injury from sharp blade
Before cleaning the appliance, pull out the power lead
plug from the mains and remove the blade. Do NOT
grip the blade by the cutting surface, but by the blade
attachment.
Cleaning position -remove adjustment plate
