346117
11
Zoom out
Zoom in
Previous page
1/12
Next page
Instructions for Use
13
Trouble-Shooting Guide
During the service, you can come across some
troubles that in most cases result from improper
handling of the appliance and can easy be
eliminated.
The Appliance Fails to Operate
After Connecting to the Mains
Supply
Check the supply in the outlet socket and make
sure the appliance is switched on (thermostat
knob in operating position).
Continuous Operation of the
Cooling System
The door was frequently opened or it was left
opened for too long.
The door is not properly closed (the door may
sag, the gasket may be polluted or damaged).
Perhaps you have overloaded the appliance
with fresh foods.
The reason may be inadequate ventilation of
the compressor and condenser (assure
adequate air circulation and wipe off the
condenser).
Ice Formation on the Inner Rear
Wall
As long as the defrost water runs to the channel
and through the outlet to the drain pan on the
compressor, automatic defrosting of the
appliance is assured.
In case the ice formation on the inner back wall is
increased (3-5 mm), ice should be manually
defrosted.
Set the thermostat knob to STOP position and
leave the door open. Never use electric devices
for defrosting and do not scrape the ice or frost
layer with sharp objects.
After completed defrosting, turn the knob to
desired position and close the refrigerator door.
The cause of increased ice formation may be one
of the following:
the door does not seal well (clean the gasket if
it is contaminated, or replace it if it is damaged);
the door was frequently opened or it was left
opened for too long;
the food stored in the refrigerator was warm;
the food or dish is touching the inner back wall.
Water is Leaking From the
Refrigerator
In case the discharge water outlet is clogged, or
the defrost water drips over the channel, water
leaks from the refrigerator.
Clean the clogged outlet, for example with a
plastic straw.
Manually defrost the increased ice layer. See
Ice Formation onthe Inner Rear Wall.
Noise
Cooling in refrigerating-freezing appliances is
enabled by the cooling system with compressor,
which produces noise. How noisy the appliance is
depends on where it is placed, how it is used and
how old the appliance is.
During the operation of the compressor the
noise of liquid is heard and when the
compressor is not operating, the refrigerant flow
is heard. This is a normal condition and it has
no influence whatsoever on the lifetime of the
appliance.
After starting the appliance, the operation of
the compressor and the refrigerant flow may be
louder, which does not mean that something is
wrong with the appliance and it has no
influence on the lifetime of the appliance.
Gradually the noise is reduced.
Sometimes unusual and stronger noise is
heard, which is rather unusual for the
appliance. This noise is often a consequence of
inadequate placing.
The appliance shall be placed and levelled
firmly on solid base.
It should not touch the wall or kitchen units
standing next to it.
Check the accesories in the interior of the
appliance, they should be placed correctly in
their positions; also check the bottles, tins
and other vessels that might touch each other
and rattle.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje r 4223 w at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje r 4223 w in the language / languages: English as an attachment in your email.

The manual is 0,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info