357990
6
Zoom out
Zoom in
Previous page
1/6
Next page
Instructions for Use
14
Trouble-Shooting Guide
During the service, you can come across some troubles that in
most cases result from improper handling of the appliance and
can easy be eliminated.
The Appliance Fails to Operate After Connecting to the
Mains Supply
Check the supply in the outlet socket and make sure the
appliance is switched on (thermostat knob in operating
position).
Continuous Operation of the Cooling System
The door was frequently opened or it was left opened for too
long.
The door is not properly closed (the door may sag, the
gasket may be polluted or damaged).
Perhaps you have overloaded the appliance with fresh
foods.
The reason may be inadequate ventilation of the compressor
and condenser (assure adequate air circulation and wipe off
the condenser).
Ice Formation on the Inner Rear Wall
As long as the defrost water runs to the channel and through
the outlet to the drain pan on the compressor, automatic
defrosting of the appliance is assured.
In case the ice formation on the inner back wall is increased (3-
5 mm), ice should be manually defrosted.
Set the thermostat knob to STOP (0) position and leave the
door open. Never use electric devices for defrosting and do not
scrape the ice or frost layer with sharp objects.
After completed defrosting, turn the knob to desired position
and close the refrigerator door.
The cause of increased ice formation may be one of the
following:
the door does not seal well (clean the gasket if it is
contaminated, or replace it if it is damaged);
the door was frequently opened or it was left opened for
too long;
the food stored in the refrigerator was warm;
the food or dish is touching the inner back wall.
Water is Leaking From the Refrigerator
In case the discharge water outlet is clogged, or the defrost
water drips over the channel, water leaks from the refrigerator.
Clean the clogged outlet, for example with a plastic straw.
Manually defrost the increased ice layer. See Ice Formation
on the Inner Rear Wall.
Noise
Cooling in refrigerating-freezing appliances is enabled by the
cooling system with compressor, which produces noise. How
noisy the appliance is depends on where it is placed, how it is
used and how old the appliance is.
During the operation of the compressor the noise of liquid
is heard and when the compressor is not operating, the
refrigerant flow is heard. This is a normal condition and it
has no influence whatsoever on the lifetime of the appliance.
After starting the appliance, the operation of the
compressor and the refrigerant flow may be louder, which
does not mean that something is wrong with the appliance
and it has no influence on the lifetime of the appliance.
Gradually the noise is reduced.
Sometimes unusual and stronger noise is heard, which is
rather unusual for the appliance. This noise is often a
consequence of inadequate placing.
The appliance shall be placed and levelled firmly on
solid base.
It should not touch the wall or kitchen units standing next
to it.
Check the accesories in the interior of the appliance,
they should be placed correctly in their positions; also
check the bottles, tins and other vessels that might
touch each other and rattle.
Bulb Replacement
Before replacing the light bulb, disconnect the appliance form
the power supply.
Press the cover at the rear side (in the arrow 1 direction) and
remove the plastic cover (in the arrow 2 direction). Replace the
bulb with a new one (E14, max. 15 W).
Don't forget: the old bulb does not belong to organic waste.
Light bulb is consuming good therefore our in-guarantee
service does not relate to it.
WE RESERVE THE RIGHT TO ALTER THE SPECIFICATIONS WITH NO INFLUENCE ON THE
OPERATION OF THE APPLIANCE
.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje r 2907 cla at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje r 2907 cla in the language / languages: English as an attachment in your email.

The manual is 0,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info