728259
11
Zoom out
Zoom in
Previous page
1/22
Next page
98
4. Attach the Filter Box
1) Screw and fasten the lter holder to the left/right side of
the back of refrigerator.
* In case the holder is not fastened well, remove the
back paper of the tape on the lter holder and attach it.
2) Insert the lter box into the holder.
6. Fasten the Water Tube.
1) Fasten the Water Tube with the [Fastener A] .
2) Check if the tube is bent or sqeezed. If so, set it right to
prevent any water leak.
7. After installation of Water Supply System
1) Plug in the refrigerator, press the [WATER] button on
the control panel for 2~3 minutes to remove any air
(bubble) in the pipes and drain out the initial water.
2) Check for the water leaks again through the water
supply system (tubes, connectors and pipes)
Rearrange the tubes again and do not move the
refrigerator.
Information concerning the water lter
- After use, the water system is subject to low pressure.
Proceed with caution when removing the lter.
- Flush the water system if the appliance has not been in
use for a long period of time, or if the ice/water has an
unpleasant taste or smell. To do this, dispense water
through the water dispenser for several minutes.
If the unpleasant taste or smell remains, replace the lter.
- Protect from frost: remove the lter cartridge if you expect
the temperature to drop below freezing.
- If pressure surges could occur in the water pipe, do not
install the water lter without a suitable surge eliminator.
Contact an installation expert if you are not sure whether
pressure surges could occur in the water pipe.
- After installing a new lter:
Discard any ice produced in the rst 24 hours after
switching on.
- If no ice has been removed for a long period of time,
empty the ice box and discard any ice produced over the
next 24 hours.
5. Connect the Water Tube to the refrigerator.
1) Remove the rear cover at the bottom back of the
refrigerator.
2) Insert the fastening ring into the Water tube. (Be careful
to follow the direction of the nut.)
3) Insert the Water Tube into the top of the water valve,
turn the nut clockwise to fasten it. (The water valve is to
the right of the motors.)
4) Check for any bent tubes or water leaks; if so, recheck
installation procedure.
5) Replace the rear cover. (The water tube should be
placed between the groove of the refrigerator back and
motor cover.)
Set the tube upright as the gure shows.
Water tube
Water tube
Nut
Water valve
Fastener A
Tap
Connector
Water tube
Water tube
ADQ501-10a(IM)(영)_Gorenje향.indd 9 2017-04-11 오후 4:56:04
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje NRS9182C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje NRS9182C in the language / languages: English as an attachment in your email.

The manual is 10,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info