a. ECO mode：the default temperature setting is 22℃,when the room temperature is
lower than 18℃,the machine works with high power；when the room temperature
is between 18℃ and 22℃,the machine works with low power。when the room
temperature is above 22℃,the heating element will be turned off。
b. when the ECO function is operating, the button is not active.
c. when the room temperature is above 22℃,the heater and swing function will also
be turned off.
6. In working condition, press button to turn on/off the swing function, Led_ will light
up/off accordingly.
7. In working condition, press or button to set the timer.
a. timer：press or key, and Led_ will display, press +/- key to set the
timer (within a range of 0-24 hours), the time will increase or decrease 1h for every
press.
b. After entering into timer by pressing or button, the time you set before
will not be changed. But you can reset the time by pressing +/-key, no operation to
the keys after 5 seconds and the time that you have reset will be effective at once.
c. If there is no operation to the keys after 5 seconds or press other keys except +/-
,the display panel will shift to show the setting temperature immediately.
d. When time was set except “0”, it will decrease 1h per time, if the timer turns to value
0, then the device will turn off at once, and enter into standby mode.
e. If the timer set as “0”, it means that no timer is set.
8. In working condition, press or button to set the temperature.
a. Temperature setting function：press or key, and Led_ SET℃ will
display, press +/- key to set the temperature, The range of the temperature is from
15°C to 35°C, the temperature will increase or decrease 1°C for every press.
b. After entering into temperature setting by pressing or button, the
temperature you set before will not be changed. You can reset the temperature by
pressing +/-key, no operation to the keys after 5 seconds and the temperature that
you have reset will be effective at once.
9. When both the time and temperature are set, the LED display shows the setting
temperature and timer display interactively for each 30 seconds. When the time is not
set, it only shows the setting temperature.
10. When turn on the heater or under standby mode, press button to turn on/off the
fireplace function, the LED will light up/off accordingly.
a. turn on fireplace function：fireplace motor works, Led_ lights up,
b. turn off fireplace function：fireplace motor stops to work, Led_ lights off。
11. Memory function in standby mode:
a. When the heater is turned on except the first time, and under the standby mode,
press key, and the unit will memorize the previous settings(except timer setting)
of last using and work accordingly.
12. After working for 1 minute, the brightness of the LED display will reduce to 1/3 of the
normal brightness, in order to avoid the problem of LED display dazzling at night. It will
resume to the normal brightness after operation.
13. There is a tip-over switch inside the heater, it will disconnect the heater automatically if
the machine falls down on the ground.
14. Remarks:
a. when the heater sensor is actived (temperature is above 60°),the LED will display
“EE”, and can not set the temperature at the moment.
b. When the environment temperature lower than -10℃, the LED will display “LO”
