512707
26
Zoom out
Zoom in
Previous page
1/26
Next page
Instructions for Use
57
Leveling the cooker
The height of the cooker with the support is 90
cm, and without support it is 85 cm. Left and right
side of the support is equipped with two wheels to
facilitate relocation. In the front part, on both
sides there are two adjustable screws, used to
level the cooker and adjust its upper edge in line
with the adjacent kitchen furniture.
Adjustable legs are accessible when the drawer
is pulled out. Adjust the position of the cooker by
turning the legs in one direction or another.
Adjustable legs will be turned easier if the
appliance is somewhat lifted up and tilted.
Drawer
The drawer is protected against accidental
opening. If you want to open the drawer slightly lift
it first and then open it. In case you want to
remove it from the appliance pull it out until it
stops, lift it and again pull it out.
Never store inflammable, explosive or heat
sensitive material in the drawer.
Place the storage drawer by inserting the rear
bottom slide into the cooker guides.
Instructions for Connection
Important Warning
Before any intervention, disconnect the power
supply. Considering the mains voltage the
appliance should be connected in accordance with
one of the following connecting possibilities.
Protective conductor (PE) must
be put on terminal pin
.
Connection should be performed by qualified fitter
only.
Before attempting to connect the appliance check
wheter the voltage indicated on rating plate
corresponds to mains voltage.
The rating plate of the cooker containing general
data is at the edge of the oven and is visible when
the door is open
When the appliance is connected to power supply
switch on all heating elements for about 3 minutes
in order to check their operation.
The electric installation should have switching
device that disconnects the aplliance from mains
in any pole. In open position the distance between
contacts should be at least 3 mm. LS switches
and fuses are considered to be good protection.
This appliance can be connected to three-phase
or two-phase power supply 3N AC
400 V with neutral conductor, but may as well be
conected to AC 230V.
When selecting the connector, consider the
capacity of the power supply and fuses. Supply
cord should be directed through relief device
which protects the cord against accidental pulling
out.
Terminal pins are accessible when you remove
the rear wall of the appliance.
The following can be used for connection:
rubber connection cables (type HO 5RR-F
with green-yellow protective conduit)
PVC insulated connection cables (type
HO 5VV-F with green-yellow protective
conduit) or
any other suitable cable of equal or better
properties.
Connection Terminal
Bridges are inserted between connectors N-N on
terminal pin.
WE RESERVE THE RIGHT TO ALTER THE SPECIFICATIONS WITH NO INFLUENCE
ON THE OPERATION OF THE APPLIANCE.
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje HEC50PP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje HEC50PP in the language / languages: English as an attachment in your email.

The manual is 1,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info