Positioning the Appliance
How to Drain Excess Water From Hoses
If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained directly
into the sink. It will b e necessary to drain excess water from hoses into a bowl or suitable
container that is held outside and lower than the sink.
Water Outlet
Connect the water d rain hose. The drain hose must be correc tly fi tted to av oid wate r leaks.
En sure that the water inlet hose is not kinked or squashed.
The following things should be checked before starting the dishwasher.
Syphon Connection
Insert the drain hose into a d rain pipe with a minimum diameter of 40mm, or let it run into the sink, making sure to
avo id bending or crimping it. The top of the hose must be less than 100 0mm.
The content of this manual is very helpful to the users.
After installation, please make sure to keep this manual.
Extension Hose
If you need a drain hose extensi on, make sure to use a similar dra in hose.
It must be no longer than 4 metres; o therwise the cleaning effect of the dishwasher could be reduced.
1The dishwasher is level and fixed properly
2The inlet valve is open
3There is a leakage at the connections of the conducts
4The wires are tightly connected
5The power is switched on
6The inlet and drain hoses are knotted
7All packing materials and printings should be taken out from the dishwasher
Position the appliance in the desired location. The back should rest against the wall behind it, and the sides,
along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain hoses that can
be positioned either to the right or the left sides to facilitate proper installation.
A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher. If your sink
has one, it is recommended thet the hose be disconnected and the hole plugged.
1.Pull The safety supply hoses completely out from storage compartment located at rear of dishwasher.
2.Tighter the screws of the safety supply hose to the faucet with thread 3/4inch.
3.Turn water fully on before starting the dishwasher.
The safety supply hose consists of the double wa lls. The hose's system guaran tees its intervention by block ing t he
flow of wate r in case of the supply hose breaking and whe n the air space between the supply hose itself and the outer
corruga ted hose is full of water.
5VSO PGG UIF XBUFS
3FMFBTF UIF XBUFS QSFTTVSF CZ EFQSFTTJOH UIF QSFTTVSF SFMFBTF CVUUPO 5IJT SFMJFWFT XBUFS QSFTTVSF BOE QSPUFDUT ZPV BOE UIF SPPN GSPN TFWFSF
TQMBTIJOH
6OTDSFX 5IF TBGFUZ TVQQMZ IPTF GSPN UIF GBVDFU
The appliance must be connected to the water mains using new hos e-sets. The old hose-sets
should not be reused.
Water pressure must be b etw een 0,04 MPa and 1 MPa. If the pressure is be low the minimum
consult our Service Depa rtment for advice.
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the
water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked
and damage the appliance.
