336345
13
Zoom out
Zoom in
Previous page
1/25
Next page
GB
Maintenance
Gas
Prior to any operation, disconnect
the appliance from the electrical
system. For long-life to the equip-
ment, a general cleaning operation
must take place periodically, bear-
ing in mind the
following:
• the glass, steel and/or enamelled
parts must be cleaned with suitable
non-abrasive or corrosive products
(found on the market).
Avoid chlorine-base products
(bleach, etc.);
• avoid leaving acid or alkaline sub-
stances on the working area
(vinegar, salt, lemon juice, etc.).
• the wall baf e and the small cov-
ers (mobile parts of the burner)
must be washed frequently with
boiling water and detergent, taking
care to remove every possible
encrustation. Dry carefully and
check that none of the burner holes
is fully or partially clogged;
• the electrical parts are cleaned
with a damp cloth and are lightly
greased with lubricating oil when
still warm.
• the stainless steel grids of the
working area, after having been
heated, take on a bluish tint which
does not deteriorate the quality.
To bring colour back to its original
state, use a slightly abrasive
product.
N.B.- Cleaning of the
taps must be carried out
by quali ed personnel,
who must be consulted
IT
Manutenzione
Gas
Prima di ogni operazione
disinserire elettricamente
l’apparecchiatura. Per una
maggiore durata ell’apparecchiatura
è indispensabile eseguire eriodica-
mente un’accurata pulizia
generale tenendo presente
quanto segue:
• le parti in vetro, acciaio e/o smal-
tate devono essere pulite con
prodotti idonei (reperibili in com-
mercio) non abrasivi o corrosivi.
Evitare prodotti a base di cloro
(varechina, ecc.)
• evitare di lasciare sul piano lavoro
sostanze acide o alcaline (aceto,
sale, succo di limone, ecc.)
• gli sparti amma ed i coperchietti
(parti mobili del bruciatore) vanno
frequentemente lavati con acqua
bollente e detersivo avendo cura
di togliere ogni eventuale
incrostazione, asciugati accurata-
mente, controllare che nessuno dei
fori dello sparti amma
risulti otturato anche parzialmente.
• le piastre elettriche si puliscono
con uno stro naccio umido e si
ungono leggermente con olio lubri -
cante quando sono ancora tiepide.
• le griglie inox del piano di lavoro
dopo essere state riscaldate assu-
mono una colorazione bluastra
che non ne deteriora la qualità. Per
riportarle all’aspetto originale usare
un prodotto leggermente abrasivo.
N.B.- L’eventuale lubri cazione
dei rubinetti deve essere eseguita
da personale quali cato al quale è
bene rivolgersi in caso di anomalie
di funzionamento.
Controllare periodicamen
te lo stato di conservazione
del tubo essibile di
alimentazione gas. In caso
di perdite richiedere
l’immediato intervento del
personale quali cato per
la sostituzione.
FR
Entretien
Gaz
Avant de toute opèration, dé-
brancher l’appareil du reseau
électrique. Pour assurer une longue
vie á l’appareil il faut absolument
effectuer de temps en temps un
nettoyage général soigneux en
gardant à l’esprit ce qui suit:
• les parties en vitre, acier et/ou
émaillées doivent etre nettoyées
avec des produits appropriés
(faciles à trouver ans les magasins)
non abrasifs ni corrosifs. Eviter les
produits qui contiennent du chlore
(eau de Javel.etc,)
• éviter de laisser sur la table de
travail des substances acides
ou alcalines (vinaigre, sel, jus de
citron, etc.)
• les ori ces du bruleûr et les cha-
peaux (pièces mobiles du bruleur)
doivent etre frequemment
lavés avec de l’eau bouillante et du
détergent, en ayant soin d’enlever
tout incrustation, ensuite ils
doivent etre essuyés soigneuse-
ment, en controlant
que tous les trous soient dé-
bouchés.
• les plaques électriques doivent
être nettoyées avec un torchon hu-
mide et un peu huilées quand elles
sont encore tièdes.
• les grilles inox du plan de travail
après avoir été chauffées prennent
une couleur bleuâtre qui ne deter-
ieoure pas leur qualité. Pour leur
rendre leur aspect original
employer un produit un peu abrasif.
N.B.: - Le graissage eventuel
des robinets doit etre faite par des
spécialités, qui doivent etre appelés
en cas d’anomalie de fon
ctionnement. Controler de temps
en temps l’état de conservation du
conduit exible d’alimentation
gaz. Si il y a des fuites remplacer
immediatement. Dans tous les cas
ne pas oublier de la changer avant
la date limite indiquée sur le
tube.
12
GB,IT,FR,...,H,RO.indd 13GB,IT,FR,...,H,RO.indd 13 9.1.2006 13:39:439.1.2006 13:39:43
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje gms 2700 p2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje gms 2700 p2 in the language / languages: English as an attachment in your email.

The manual is 0,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info