326513
4
Zoom out
Zoom in
Previous page
1/15
Next page
Instructions for use and installation
6
After that you can set the burning power between high and
low position to suit your cooking requirements.
Button positions between
in are not recommended.
In these positions the flame is not stabilized and may be
extinguished.
If the flame goes out repeat the procedure.
If the burner flame goes out (for whatever reason), shut the
burner off and wait for at least one minute before next
attempt.
Note: before igniting the burners (triple-ring burner, double-
ring burner, and Mini Wok) cover them with appropriate
cookware.
To shut the burner off turn the button to the right, to the OFF
position
(CLOSED).
Gas faucet is closed
Maximum power position
Minimum power position
To facilitate positioning small dishes on the burner grid, place
the attached support extension over the auxiliary burner.
.
Cookware
Selection of the adequate dish size ensures optimized cooking
time and consumption of gas. Diameter of the dish is of utmost
importance.
The flame reaching over the edge of the small diameter dish
may destroy the dish, while the consumption of gas is
increased.
Gas needs oxigen for burning. In case of excessively large
dish diameter the oxigen supply is insufficient, consequently
reducing the burning capacity.
The wire grid (certain models only)
The wire grid is used for dishes with small diameter. Place the
grid over the auxiliary burner crown.
Burner type Dish diameter
Large (3,0kW) 220-260 mm
Normal (1,9kW) 180-220 mm
Auxiliary (1,0kW) 120-180 mm
Triple-ring (3,5kW) 220-260 mm
Oven
Important warnings!
Never put aluminum foil to the bottom of the oven, and do
not place any crockery upon it, since the foil may impede the
circulation of air, and the oven enamel may be damaged by
the excessive heat.
Fruit juice, dripping from the baking pan, may produce stains
upon the enamel, which are very hard to remove.
Oven burner is thermally protected. In case the flame
accidentally goes off, the gas supply is automatically shut
off.
The oven temperature is regulated by a thermostat.
Regulation is active only with the oven door shut.
The oven bottom plate must be in place during operation.
Never leave food to cool down within the oven, since
this may cause condensation and rusting.
Modes of operation
Oven is controlled by the function mode selection knob. To
select the desired position Press the button towards the
appliance and turn it in either direction.
Conventional heating with gas burner
In this mode the oven is heated by the oven gas burner.
Baking and roasting is possible only at single level.
Heating with infrared gas burner
(certain models only).
Heat comes directly from the infrared burner located at the
oven ceiling. This mode actually provides grilling of food.
During the operation of infrared burner the oven is not
controlled by the thermostat – the burner constantly
operates at full power!
Heating with infrared electric heater
Heat comes from the electric infrared heater located at the
oven ceiling.
This mode is specially suitable for grilling minor roasts, like
roast beef, sausages, various steaks, pork chops, etc.
Electric infrared heater may be applied also for broaching of
chicken (certain models only).
Press the oven function mode towards the control panel and
turn it to the right, to the position of grill/broach symbol, and the
infrared grill/broach heater is switched on (certain models
only).
Grilling temperature is 240°C. Once this
temperature is reached the heater is switched off
and when the oven temperature drops under
240°C the heater is turned on again. Heater operation is
signaled by the red indicator light.
Oven burner ignition and operation
·Press the oven burner button towards the control panel and
turn it to the
position. At the same time press the
ignition device button, or strike a match to the oven burner
ignition opening and ignite the gas.
After ignition keep the button pressed for further 5-10
seconds to stabilize the flame, then release the button and
set it to the desired heating power between 8 and 1.
If the oven burner fails to ignite after 15 seconds, shut the
burner off, open the oven door and wait for at least 1 minute
before the next ignition attempt.
Oven temperature is regulated by the thermostat.
Immediately after ignition it operates at maximum power until
the preset temperature is reached. Then the thermostat
reduces the burner power to the value required for
maintaining the preset temperature. This regulation works
only when the oven door is shut.
If for any reason whatsoever the oven burner flame goes
out, shut the burner off immediately and wait for at least 1
minute with the oven door opened before attempting to
repeat the ignition procedure.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje gin 4703 w at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje gin 4703 w in the language / languages: English as an attachment in your email.

The manual is 0,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info