728456
23
Zoom out
Zoom in
Previous page
1/24
Next page
302967
23
Problem: Cause or remedy:
After connecting to the power
mains, the appliance does not
operate:
• Make sure the wall outlet is powered and that the appliance
is plugged in.
Cooling system has been
working continuously for a long
period of time:
• Too high environment temperature.
• Door is open too often or it is left open too long.
• Door is not closed appropriately (there may be dirt between
the door and the refrigerator, the door may be tilted, the seal
should be checked, etc.).
• Too much fresh food was inserted.
• Insuffi cient compressor and condenser cooling. Check the air
circulation behind the appliance and clean the condenser.
Ice accumulation in the freezer
interior is a result of:
• Poor door sealing. If the seal is dirty or damaged, clean or
replace it.
• Door is opened too often or left open too long.
• Placing warm food into the freezer.
D light is on/is fl ashing: • Frequent opening of the door, door open too long.
• Door not closed properly (particle between door gasket,
sagged door, damaged gasket, etc...).
• Excessively long power failure.
• Excessive quantity of fresh food inserted at once.
Door won’t open easily: • If you wish to open freezer door immediately or shortly after
closing it, you may feel rather strong resistance. When the
freezer door is opened, some cool air escapes from the
freezer compartment and it is replaced by warm air from the
environment. When this air is cooled, a sub-pressure builds
up, causing resistance to door opening. After a few minutes,
the condition is normalized and the door can be easily
opened again.
Bulb replacement (certain
models only):
• Before replacing the light bulb, disconnect the appliance form
the power supply. Remove the plastic cover, replace the bulb
with a new one (E 14, max. same voltage as the factory one)
and fi t back the cover.
• Please dispose of this correctly.
• Light bulb is consumption material and is not covered by the
warranty.
• Bulb lamps used in this appliance are special purpose lamps
selected for household appliances use only. They are not
suitable for household room illumination.
Signal light B is fl ashing: • If the signal light B is fl ashing, call a service technician.
Occurrence of murmur after
closing the door:
After closing the door, some murmur can occur. This
phenomenon is normal and is due to pressure equalisation
.
Error code displayed (certain
models only):
If the character E appears on the digital display (certain
models only), call service assistance.
If none of the above reasons seems to match your problem, please contact the nearest service
center and state the type, model and serial number as indicated on the label with basic information
attached in the appliance interior.
Troubleshooting
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje F6182AW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje F6182AW in the language / languages: English as an attachment in your email.

The manual is 1,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info