336808
11
Zoom out
Zoom in
Previous page
1/12
Next page
233036
‘’ The appliances are suitable for photovoltaic electrical power
under the condition that electrical voltage will be 220VAC
- 240VAC with semi tonic frequency 50Ηz in order the appliance
to operate properly (alternative a generator can be used with the
same technical characteristic).’’
The cooking hob should be earthed by a ring of the yellow-green
earthing wire that is factory- tted on the built-in hob. Attach
the cable shoe of the earthing wire to the earthing clip on the
oven frame using a star washer and a nut. The earthing clip is
indicated by the earthing symbol
.
1 - Connector plugs
2 - Connector plugs
3 - Green-yellow earthing wire with a cable shoe
Ground connection of
the built-in cooking hob
Ground connection of
the built-in cooking hob
The appliance may only be connected by an authorized skilled technician.
Electric system protection should comply with all relevant regulations.
The connection clips can be accessed when the connection clip covers are opened / removed.
Before connecting the appliance, make sure the voltage indicated on the rating plate is
consistent with the voltage in your home circuit.
The rating plate with basic information is attached on the lower side of the hob.
The electric circuit should also include an omnipolar switch that will separate the appliance from
the mains, if required, with at least 3 mm of distance between contacts. Suitable devices include
fuses, current protection switches, etc.
The connection should be selected according to the installation possibilities with regard to
current and fuses.
Given the protection from the risk of re, appliances of this type may be installed in a worktop
next to a piece of kitchen furniture that is taller than the appliance (when installed); however, in
this case, a kitchen furniture not higher than the cooking hob must be installed on the other side,
adjacent to the appliance.
The current conducting and isolated parts must be protected from any possibility of direct contact.
WARNING!
Before any intervention, disconnect the appliance from the power mains. Connect the built-
in cooking hob to the kitchen range using two connector plugs. The plugs are installed on the
hotplate or cooking zone leads, while the corresponding sockets are attached to the oven frame,
behind the switchboard. Connect the two parts of the kitchen range by inserting the plugs into the
corresponding connector sockets without using any tools.
Important: the design of the connector plugs allows them to be connected in one way only.
Therefore, make sure to nd the right, i.e. matching pair of connectors (the plug should slide into
the socket with a click, when pressed lightly). If, by mistake, you attempt to connect a pair of non-
matching connectors, their respective designs will mechanically prevent you from doing so. In such
case, try connecting the plug to the following socket.
11
Connecting the appliance to the power mains
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje ecd 620 ex at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje ecd 620 ex in the language / languages: English as an attachment in your email.

The manual is 0,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info