326234
13
Zoom out
Zoom in
Previous page
1/16
Next page
Instructions for use, installation and connection
116
Simple cleaning
It is reccommended to use a special type of wet cleaning,
without the use of expensive cleaners. Insert deep roasting pan
into the 2
nd
guide and pour approximately 0,4 l water in it.
Select the cleaning mode symbol (
), set the temperature to
50°C and the time to 30 minutes. The bottom heater will
automatically switch off after the set time had expired, while
the accumulated steam will soak and soften the stains in the
oven. Remove the guides and wipe the interior of the oven
(bottom, walls) with a moist cloth or a sponge.
Catalytic coating of the oven
Catalytic enamel is soft and sensitive to rubbing and
therefore we warn against the use of abrasive cleaning
agents and sharp objects.
Rough catalytic enamel speeds up disintegration of grease
and other filth. Smaller stains that remain after cooking
usually disappear during the next use of the oven. As a rule,
the stains disappear at the temperatures above 220°C, while
at lower temperatures their disappearance is only partial.
Self cleaning power of catalytic parts gradually faints. We
suggest replacement of old coatings after a couple of years
of regular use.
Some useful hints
When roasting large pieces of fatty meat we recommend
that you wrap them in aluminium foil or put them in a suitable
roasting bag to prevent the grease from splashing all over
the oven.
Place the drip pan underneath the grid when using the grill.
Removing wire and telescopic guide grids
Telescopic guide grids or wire guides may be removed to
facilitate the cleaning of the oven. Side grids are removed by
swinging the bottom side inwards and unhooking them from
their place.
Clean the side grids and telescopic guides only with
conventional detergents.
Telescopic guides may not be washed in a dishwasher.
Note! Never lubricate the telescopic guides!
To reinsert, repeat the procedure backwards: slide them into
the holes and swing downwards.
Oven ceiling
To facilitate the cleaning of the ceiling some ovens are
equipped with the foldable infrared heater
Before lowering the infrared heater disconnect the appliance
from the mains by unlocking the fuse or switching off the
main switch.
The heater must be cooled down, otherwise you might get
burned!
Never use the heater in the lowered position!
Before cleaning remove all pans, grids and guides, and using
suitable tools (knife or a screwdriver) loosen the cross bar from
its side supports (see fig.). Use your other hand to hold the
heater and fold it downwards.
After cleaning simply push the heater back and the cross bar
will click into position.
Removing oven door
(certain models only)
Open the door to the horizontal position. Pull the bottom hinge
supports upwards to the vertical position and lock them to the latch
of upper hinge support. Close the door halfway (see fig.) and pull it
out. For reinserting the door repeat the procedure backwards. Insert
the door in half open position (at an angle of 60°) by pushing them
all the way in during opening. Be sure that the notches on bottom
hinge carriers fit exactly the oven floor. Now open the door
completely, remove the hinge clamps from the upper hinge latches
and return them into the horizontal position.
1 door hinge in 2 door hinge during
operating position dismantling
Removing oven door with a single axe hinge
(certain models only)
Open the door completely and turn the removable locks backwards
(see fig). Then close the door slowly and let the locks fit to the
notches. At an angle of about 15° lift the door slightly up and pull
the door from the hinge supports (fig. 2). For reinserting the door
repeat the procedure backwards. Insert the door at an angle of
about 15° into the hinge supports by pushing them forward and
downwards, so the hinges lock into their slots (fig. 3). Check if the
hinges are locked into their respective slots.
Now open the door completely and turn the removable locks into
their original position. Close the door slowly and check if they close
properly (fig. 4). If you have trouble closing the door, check if the
hinges are properly inserted into their slots.
Attention! Never let the hinge locks spring out, as the springs are
strong and may cause injuries.
Fig. 1 Fig. 2
Fig. 3 Fig. 4
Accessories
Accessories, like biscuit tray, oven grid, etc. are cleaned with
hot water and the usual detergent.
Special enamel
Oven, interior door lining, baking tray and grease interception
pan are coated with special enamel, with smooth and resistant
surface.
This special coating facilitates cleaning at room temperature.
Grease filter
Clean the grease filter after each use with soft brush in hot
water with some detergent, or wash it in the dishwasher.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje ec 7969 e w b at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje ec 7969 e w b in the language / languages: English as an attachment in your email.

The manual is 1,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info