326968
14
Zoom out
Zoom in
Previous page
1/15
Next page
Instructions for use, installation and connection
34
by inserting the screwdriver into
the slot and pull in the direction
of the arrow (see Fig.).
Remember that the bulb is
regarded as consumption
material and is not covered
by the warranty.
Instructions for installation and connection
Safety precautions for the technician
Installation may be carried out only by qualified personnel.
The electric installation shall be equipped with a safety
device, able to disconnect the appliance from mains in all
wires, with the distance between contacts of not less than 3
mm in open position. Good protection is provided by the LS-
switches and/or fuses.
The connection may be carried out by rubber mains lead
(type HO5RR-F with green/yellow earth wire), PVC insulated
mains lead (type HO5VV-F with green/yellow earth wire) or
other cables of equal or better quality.
Distance between the cooktop and the kitchen hood must be
at least the distance, indicated in the instructions for use of
the kitchen extraction hood.
Panels, glue and furniture lining from artificial materials,
adjacent to the appliance must be temperature resistant
(>75°C), otherwise they might be deformed.
Mains lead behind the cooker must be placed in such
manner to avoid touching the back panel of the cooker
because of the heat it develops during operation.
Remove any packaging materials (foils, artificial foam, nails,
etc.) from the reach of children, because they represent
potential danger. Children may swallow small parts, or
suffocate with foils.
Leveling the appliance and extra support
(certain models only)
The height of the cooker with the support is 90 cm, and
without support it is 85 cm. Left and right side of the support is
equipped with two wheels to facilitate relocation. In the front
part, on both sides there are two adjustable screws, used to
level the cooker and adjust its upper edge in line with the
adjacent kitchen furniture. Adjustable legs are accessible when
the drawer is pulled out. Adjust the position of the cooker by
turning the legs in one direction or another. Adjustable legs will
be turned easier if the appliance is somewhat lifted up and
tilted. Additional support may be removed by unscrewing the
four screws holding it to the bottom of the cooker. In such case
relocate the Some cookers are equipped with four adjusting
screws (two in front and two at the back), used for leveling the
appliance or adjusting its heights to match the adjacent
furniture.
Electric connection
Open the connection box using the screwdriver, as
shown by the drawing on the cover.
Connection to the mains power can be done only by
the authorized service center or by qualified
personnel! Wrong connection may damage the parts of
appliance and render your warranty viod! Connecting
voltage of the user’s installation (230 V against N) must be
verified by qualified electrician using the appropriate tester.
Connector bridges must be positioned in accordance with
the installation connection!
Prior connecting the appliance, check whether the voltage of
the rating plate corresponds to the actual voltage of home
installation.
Length of the power lead must be at least 1.5 m so that the
appliance can be connected to power before pushing it
against the wall.
Length of the earthing lead must be longer than the others,
so that it is strained later than the tension power leads in
case of accidental pullout from the socket.
Procedure
Using the screwdriver open the connection box cover at the
back of the appliance. You can do so by releasing two
catches, as shown on the connection box cover.
Power cable must be guided through the relief device,
protecting it from pulling out. If the relief device has not been
fixed yet, fix it in such way to hook the power cable to the
device housing at one end.
Now connect the power cable in accordance to one of the
options shown on the figure. In case of different installation
voltages, the connection bridges should be rearranged
accordingly!
Tighten the relief device and close the connection box cover.
NOTE:
In some connection boxes the connector bridges are placed
between contacts 4 and 5, and in the others they are stored at
a designated place within the box. These boxes have the
connection screws already in open position so they need not
be unscrewed. During the tightening procedure you will hear a
faint “click”, meaning that the tightening screw should be
fastened tightly all the way.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje ec 7304 w at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje ec 7304 w in the language / languages: English as an attachment in your email.

The manual is 1,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info