303308
10
Zoom out
Zoom in
Previous page
1/20
Next page
237332
Delay can also be set / adjusted while the delay timer is in
operation, i.e. during the delay time countdown. To do this, press
the
button (C). Con rm the change by pressing the START (D)
button.
If the START (D) button is pressed during the delay timer operation
(during delay time countdown), the delay will be cancelled and the
selected drying program will start immediately.
If there was a power supply failure before the delay time has
expired, the START/PAUSE (D) button must be pressed again.
If the dryer is switched off, this function is reset to its
initial position; the delayed start function is deactivated.
Drying process is turned on by pressing the START/PAUSE
button (D); the (I) LED lights.
If you turn the program selector jog during the drying process,
settings do not change, except at the position “0”, whereby the
program is suspended.
When the set moisture level is reached, the cooling process
starts; the (I) LED goes off and the (H) LED is on.
If the ventilation program is selected
(see drying programs
table) the (H) LED is on throughout the entire program.
Cooling off period lasts 10 minutes; LED (H) is on.
Program is suspended if the drum sensor fails to detect laundry
in the drum.
The anti-crease program is active at the end of program and
remains active for 1 hour (drum occasionally spins around).
If you open the drum door after the drying cycle had been
completed, the anti-crease program is ended.
- End of drying procedure
At the end of the drying procedure the (G) LED ashes,
indicating that the drying program has ended. Signal
LED’s clean the lter (F) and drain the container (E) are
on (only for condensation type of dryer).
Open the dryer door by pushing the left-hand side of the door
towards the appliance.
Remove the laundry from the dryer.
Turn the appliance off by turning the jog selector (A) to the
position “0”.
Clean the lint lter (see chapter on Cleaning and Maintenance).
Close the dryer door.
Empty the water container (this applies for condensation dryers
only - see Cleaning and Maintenance) and replace it back to its
slot.
Drying procedureDrying procedure
10
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje d 62325 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje d 62325 in the language / languages: English as an attachment in your email.

The manual is 2,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info