330857
13
Zoom out
Zoom in
Previous page
1/17
Next page
Instructions for use, installation and connection
50
Cleaning and maintenance
Never clean the appliance with pressurized hot steam cleaner!
Before cleaning switch the cooker off and let it cool down
completely.
Front side of the casing
For cleaning of frontal part of the cooker use the usual cleaning
agents and follow the manufacturer's instructions.
Never use any aggressive cleaning agents or dish cleaning
accessories which might cause scratches.
Stainless steel front
(certain models only)
Clean the surface with mild detergent (soap) and soft sponge
which does not scratch. Never use aggressive cleaners or
solvents, otherwise you may damage the surface.
Enamel coated and plastic surfaces
(certain models only)
Clean the knobs and handles with soft cloth and liquid
cleaners, intended for use of smooth enamel surfaces.
Aluminum coated surfaces
Aluminum coated surfaces of the appliance (front) should be
cleaned with liquid non-abrasive agents and soft sponge. You
may also use cleansing agents intended for such surfaces, and
follow the manufacturer's instructions.
CAUTION: Such surfaces may never come in contact with
oven cleaning sprays, because they visibly and permanently
damage aluminum surfaces.
Oven
The oven may be cleaned in a traditional mode (using oven
cleaners and sprays).
The following procedure is recommended for regular cleaning
of the oven (after each use):
Turn the mode selection button to the position
. Set the
temperature control button of the cold oven to 50°C. Pour 0,4 l
of water into the baking pan and insert it into the bottom grid
lead. After thirty minutes the food residues upon the enamel
coating are softened, and may be easily wiped off with a moist
cloth.
Otherwise respect the following cleaning tips:
Cool the oven completely before cleaning.
The oven and the accessories must be cleaned after each
use, otherwise stains might get burned in.
Oven walls, sprayed with oil from roasting, is best cleaned
with warm water and detergent when the oven is still tepid.
Hard and heavily stained oven should be cleaned with
special oven cleaning agents. Rinse the cleaner thoroughly
and remove any detergent remaining before the next use.
Never use aggressive cleaners, like polishing agents, dish
cleaning accessories, corrosion inhibitors, or any other
devices that might cause scratches.
Coated, stainless steel or zinc-coated surfaces or aluminum
parts must not come into contact with oven sprays, since
they might cause damage or discoloration. The same goes
for thermostat probe (if the cooker is equipped with it) and
exposed heaters on the oven ceiling.
When purchasing cleaning agents remember the
environment, and strictly follow the manufacturer's
instructions.
Catalytic coating of the oven
Catalytic enamel is soft and sensitive to rubbing and
therefore we warn against the use of abrasive cleaning
agents and sharp objects.
Rough catalytic enamel speeds up disintegration of grease
and other filth. Smaller stains that remain after cooking
usually disappear during the next use of the oven. As a rule,
the stains disappear at the temperatures above 220ºC, while
at lower temperatures their disappearance is only partial.
Self cleaning power of catalytic parts gradually faints. We
suggest replacement of old coatings after a couple of years
of regular use.
Some useful hints
When roasting large pieces of fatty meat we recommend
that you wrap them in aluminium foil or put them in a suitable
roasting bag to prevent the grease from splashing all over
the oven.
Place the drip pan underneath the grid when using the grill.
Removing wire and telescopic guide grids
Telescopic guide grids or wire guides may be removed to
facilitate the cleaning of the oven. Side grids are removed by
swinging the bottom side inwards and unhooking them from
their place.
Clean the side grids and telescopic guides only with
conventional detergents.
Telescopic guides may not be washed in a dishwasher.
Note! Never lubricate the telescopic guides!
To reinsert, repeat the procedure backwards: slide them into
the holes and swing downwards.
Oven ceiling
(differ according to different models)
To facilitate the cleaning of the ceiling some ovens are
equipped with the foldable infrared heater.
Before lowering the infrared heater disconnect the appliance
from the mains by unlocking the fuse or switching off the
main switch.
The heater must be cooled down, otherwise you might get
burned!
Never use the heater in the lowered position!
Before cleaning remove all pans, grids and guides, and using
suitable tools (knife or a screwdriver) loosen the cross bar from
its side supports (see fig.). Use your other hand to hold the
heater and fold it downwards.
After cleaning simply push the heater back and the cross bar
will click into position.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje b 9010 e at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje b 9010 e in the language / languages: English as an attachment in your email.

The manual is 0,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info