650414
28
Zoom out
Zoom in
Previous page
1/52
Next page
131
TELEPHONES PROGRAMMING
rogramming the T-940 Plus telephones.
P
Switch off the telephone to be programmed.
Once the telephone is off, press the door release push button.
Set to ON the switch number 2 of the SW2 configuration dip switch, placed
at the upper left side (back) of the sound module. The door panel will
reproduce a sound to advise that the system has entered into
programming mode.
In systems with more than one door panel, the programming process shall
be done on the master door panel only.
To program the telephone from a general door panel (if it exists), see page 119.
To show that the system is ready for programming, the door
panel will reproduce a tone and the telephone led will blink.
At this moment, the door release push button can be
released. Lift the handset to establish audio communication
with the door panel.
With the door release push button pressed switch on the
telephone.
Press the door panel push buttonthat will call
to this telephone. At this moment the door
panel will reproduce a tone and the
telephone led will blink.
To program the telephone as master, switch it
off and on again.
To program it as slave, press the door release
push button.
To program it as slave with intercom function
press the center push button.
Each apartment must have one master unit only; in case of parallel units configure them as
slaves, both monitors or telephones.
Make a call to check that the telephone has been succesfully programmed.
Repeatthese steps to program the rest of telephones.
Once the programming has been finished, set to OFF the programming
switch. If you don't, the door panel will reproduce a tone to advise that the
system is still into programming mode.
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Golmar T631 Plus Nexa at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Golmar T631 Plus Nexa in the language / languages: English as an attachment in your email.

The manual is 2,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info