• Do not dig historical or
archeological objects;
• Before start looking for different
objects, read carefully normative
legislation of the country, regarding
rights of property over found
objects and those, which concern
cultural belongings of the country.
FITTING GOLDEN MASK 2
Take the lower end of the strip and
put it in the slit of the coil till them
both fit tight. Put the plastic bolt
into the opening and fit it tight so
that it goes out the opposite side
and turn the nut with light clamp.
Then fit together with the second
part of the strip and put the iron
bolt while tighten it by the winged
nut. Take the electronic set and
unscrew the plastic nut and then
slide it into the upper end of the
tube of the strip, press hard the
plastic end of the detector towards
the tube of the strip. Put the two
tubes one into another as high
according to your height. After that
tighten the nut heavily so that
detector can’t move toward the
strip. Wind up the cable around the
strip leaving an “ear” of the cable
on the lower end of the coil so that
the cable wouldn’t tear when the
coil is gathered and ready to be
transported. Then put the jack of
the cable into the nest of the
detector winding it tightly without
much strength. So the detector is
ready to be worked with.
TECHNICAL
CHARACTERISTICS
• High power electronics
• Work frequency - 8 KHz
• VLF-TR technology
• Discrimination by moving the
coil
• Audio discrimination
• Multi tonal discrimination -
VCO Sensibility control
• Eliminates ore soils and
heavy mineralization
• Manual ground balance
• Light indicator for the
condition of batteries
• Minimal consumption 35 mA
• Maximum consumption 65
mA
• Rechargeable batteries - 12V/
1000 mA
• Automatic charge device with
5 years guarantee of
electronics