656065
3
Zoom out
Zoom in
Previous page
1/5
Next page
To prevent damage to the product or injury to you or to others, read the
following safety precautions in their entirety before using this equipment.
Keep these safety instructions where users can read them for ready
reference.
To avoid overheating & damaging your flash unit, please wait for about three
minutes after 30 times continuous triggers at full power.
Do not disassemble or modify
There are high-voltage components inside the unit. Failure to observe this
precaution could result in electric shock or product malfunction. Should the
product break open as the result of a fall or other accident, send the defective
back to authorized service center for inspection and maintenance.
For Your Safety
Caution
0403
Keep dry
Do not handle with wet hands or immerse in or expose to water or rain. Failure
to observe this precaution could result in fire or electric shock.
Keep out of the reach of children
This device contains small parts that may pose a choking hazard. Consult a
physician immediately if a child swallows any part of this device.
Do not expose to high temperature
Do not leave the device in a closed vehicle under the sun or in other areas
subject to extremely high temperature. Failure to observe this precaution
could result in fire or damage to the housing or internal parts.
Do not keep long time in using the modeling lamp, otherwise the modeling lamp
will be deformed, and the flammable accessories such as softbox will get burnt.
The flash can be used at full power for five minutes continuous, and then it
should be cooled down one minute.
When using a snoot, do not keep long time the modeling lamp on or over
frequent flashlight (not over six times for one minute). Overheating will result in
damages for strobe housing and studio light.
Do not touch the lamp cap when the flash or modeling lamp is working, as it will
give out heat, leading to high surface temperature.
Avoid sudden impacts as this can damage the flash tube and/or modeling lamp.
Do not flash directly towards naked eyes (especially those of babies), otherwise
it maylead to short time visual impairment.
When not in use, disconnect from the power supply.
High voltage inside the tube outlets, please do not touch it. Hands should be dry
with insulated gloves when load/unload the flash tube and modeling lamp.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Godox Smart 160SDi at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Godox Smart 160SDi in the language / languages: English as an attachment in your email.

The manual is 2,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info