725234
9
Zoom out
Zoom in
Previous page
1/16
Next page
9
Insert the pump andsrew it in.
Operate the pump until the pressure
gauge shows notfurther increase in
pressure (the safety valve blowsoff
the excess pressure). The maximum
pressure shown on thepressure
gauge must never exceed 6,6 bar.
Make sure the unit is not pressur-
ized. If necessary, press red push-
button.
Remove the pump by turning it to the
left. To do this, first release the piston
rod, turn it 180° and transfer the-
screw force via the back of the lock-
ing pins on the pumphousing.
Fill tank. Caution!
Observe the maximum filling level
Insert pump again and screw tight
by turning in a clockwisedirection.
Connect unit and rig with supplied
hose.
Operate pump until a max. gauge
pressure of 6 bar is rea-ched (red
mark on gauge).
Check of water level
Fig.
When the unit is not under pressure
(press red button), hold upthe trans-
parent hose. The water level in the
hose is the same as that in the con-
tainer and it can be read off the fill-
ing level scale on the container
(water balance principle).
Emptying and Servicing
Operate the pressure relief valve
(red button) until the unit is no longer
under pressure.
Open the pump carefully, at first only
a few turns to the left, to allow any
compressed air still in the tank to
escape. Only then should the pump
be unscrewed completely and re-
moved from the tank.
Empty any remaining water.
After emptying, hang up the open
unit to dry.
Store the unit in a depressurised
condition.
The service life of the unit will be
greatly extended by occasionally ap-
plying resin and acid-free grease to
the sealing ring between the pump
and the tank and to the inner O ring.
3
10
9
8
7
6
5
3
RZ_976213.qxd 12.03.2007 15:34 Uhr Seite 9
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gloria 415 Profiline at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gloria 415 Profiline in the language / languages: English, German, French as an attachment in your email.

The manual is 1,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info