814062

Globe Fire Eros II Manual

3
Zoom out
Zoom in
Previous page
1/8
Next page
1. INSTALLATION OF STOVE.
The stove is ready for use and can be connected to the chimney with the flue pipe. If possible, connect the flue pipe, keeping it short, straight
or slightly at an angle to the chimney.
Seal the connection (heat resisting fire rope). When fitting the legs do not drag or push the stove but lift it (the legs could break off).
Connect the external air flow by using a pipe.
National or European standards, including local standards and any fire regulations must be complied with. Ensure that there is sufficient air
flow before burning wood. This is particularly important in well insulated houses and those with a mechanical ventilation system.
To ensure your chimney has the correct measurements it is possible to measure it. Ask your chimney sweeper for advice.
Before placing the stove into position check to see if the floor can take the weight. When in doubt place the stove on a large slab of stone
or marble to divide the weight.
2. GENERAL FIRE SAFETY INSTRUCTIONS.
During wood burning, high temperatures are reached make it impossible to touch the top, sides or door without using heat resisting gloves.
Children must be made aware of the dangers and kept away for the stove when lit.
3. TYPES OF FUEL PERMITTED.
Use blocks of wood approx. 30 cm in length and 10 cm in diameter. Certain types of coal can also be used, with the exception of black coal
and anthracite which is not recommended because of overheating causing the cast iron to warp or break.
Wood must be dry. (max. 20% moisture content) Burning synthetic materials, plastic, varnished wood or other materials is strictly
forbidden by law because of emission of harmful gasses endangering health. The chimney and stove will become severely damaged and the
smell produced is a hindrance for the neighbourhood.
Unlike gas or oil, wood cannot burn overnight.
4. OPERATION OF THE STOVE.
Lighting the stove for the first time will cause an unpleasant smell and blue damp. Leaving a window open while the paint is hardening
is recommended. Make sure the fire burns well so that the paint hardening process is successful. Once this is done threre will be no more
trouble with smell and damp. Never use methylated spirits, petrol or other fluids to light the stove, this can be very dangerous.
Using a firelighter is recommended. The wood used must not be younger than 2 years and no older than 6 years. Young wood is too wet and will
produce too much soot. Old wood is not suitable to start a fire as it no longer contains any gasses, which will prevent the right temperature being
reached quickly for a fast and clean burning.
With the technique we use, the fire will burn at its best within 15 to 20 min. Before starting the fire, check to see that all air vents are open.
When the fire is burning well, the fire grid can be closed and the flames regulated with the primary / secondary regulator.
Do not close up completely while flames are visible. (This is to avoid smoke entering the room) Stay with the stove until burning well.
If the fire has been started well the stove should remain quite clean. Wait until the wood has to a glow before putting on more logsburnt
5. GLOBE FIRE RECOMMENDATIONS “ LIGHTING THE FIRE “ ON PAGE 7.
6. AIR SUPPLY.
Always make sure there is enough air in the room.
7. USING THE FIRE IN THE AUTUMN AND SPRING.
In these seasons of the year when the outside temperature is higher your chimney may not have a good chimney draught and the smoke will not be
sucked out enough. In this case it is recommended to use a lot of dry wood (three quarters full) not older than 6 years.
Please in the first heat up, also in de transitional period, the burner as described in the
initial heating recommendation be part!
8. CARE AND MAINTENANCE.
The stove must be cleaned yearly and occasionally even more often. It is recommended that the chimney is swept every year by a professional
chimney sweeper. The Globe-fire stoves have been treated with a heat resisting paint. After this has hardened, the stove can be cleaned with
a damp cloth, using a dry cloth to dry off afterwards.The stove window can be cleaned with a glass cleaner. Badly stained glass can be cleaned
with a special gel or oven cleaner. Never clean the stove when it is hot. Remove the ash between the fire grid so that the grid can revolve easily.
Installation and operation manual for Stove model ST-2800SY
Tested according to German standards: DIN EN 13240, Ö-Standard
15A and 1.+2. BimschV., CE and Luftreinhalte-Verordnung Switzerland
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Globe Fire Eros II at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Globe Fire Eros II in the language / languages: English as an attachment in your email.

The manual is 2.18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Globe Fire Eros II

Globe Fire Eros II User Manual - German - 8 pages

Globe Fire Eros II User Manual - Dutch - 8 pages

Globe Fire Eros II User Manual - French - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info