606987
6
Zoom out
Zoom in
Previous page
1/11
Next page
7
Deleting a radio assignment
1. Press the red button for approx. 20 seconds.
After approx. 4 seconds the top red LED begins to flash, and after
20 seconds this flashing changes over to periodic flashing for approx.
6 seconds.
2. Release the red button briefly during these 6 seconds and then press
it again for approx. 1 second.
During deleting the top red LED lights up continuously again. The
successful deletion of the assignment is indicated by the top red LED
flashing rapidly.
The flashing ends after approx. 1 minute or after briefly pressing a
button.
Polling valve position (stroke display)
The stroke display shows the current position of the radio motor valve
drive. This function is, for example, helpful when it is too cold or too hot
in the room and the actual valve is to be calibrated via the potentiometer.
1. You start the stroke display by
briefly pressing two buttons
simultaneously.
The LEDs light up for approx.
3 seconds and show the current
valve opening in percent.
Actual value calibration
The measured actual temperature can be shifted on
the potentiometer of the radio motor valve drive
(approx. +6 to -2 Kelvin). For example, this is
necessary to compensate measuring deviations
when the radio motor valve drive is covered by a
cover or a curtain.
1. Unlock the cover with the special key and fold it
open.
2. Adjust the actual valve in the desired direction
on the potentiometer:
if it becomes too hot in the room, in the
direction –
if the selected temperature is not reached, in
the direction +
3. Quickly close the cover of the radio motor valve
drive and lock it with the special tool.
Connection of remote sensor
If the valve drive is mounted covered (e.g. behind a
radiator trim panel or a drapery), the temperature
measurements may be falsified. In this case it is
advisable to connect the remote sensor and position
this in the room away from the heater.
1. Break out the terminal cover on the back of the
radio motor valve drive with a small screwdriver.
2. Connect the cable of the remote sensor to the
exposed terminal.
i
Deleting by repeated teach- in
Analogous to the other components of the Gira radio bus system, the
assignment can also be deleted by teach-in the same transmitter again.
Valve opening:
> 60 %
40 - 60 %
20 - 40 %
0 - 20 %
0 %
°C
+
0
+
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gira 118700 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gira 118700 in the language / languages: English as an attachment in your email.

The manual is 0,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Gira 118700

Gira 118700 User Manual - German - 11 pages

Gira 118700 User Manual - Dutch - 12 pages

Gira 118700 User Manual - French - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info