580051
17
Zoom out
Zoom in
Previous page
1/24
Next page
17
Gigaset A410_A410A / IM_MEA en / A31008-M2402-R151-2-UZ19 / Bali_MEA_ar-fa.fm / 02.09.2013
Template Bali, Version 1, 16.02.2012
General specifications
Questions and answers
If you have any queries about the use of your telephone, visit our website at www.gigaset.com/service
for 24-hour support. The table below contains a list
of common problems and possible solutions.
Contact with liquid
If the handset has come into contact with liquid:
1 Switch the handset off and remove the battery immediately.
2
Allow the liquid to drain from the handset.
3 Pat all parts dry, then place the handset with the battery compartment open and the keypad facing down in a dry,
warm pl
ace for at least 72 hours (not in a microwave, oven etc.).
4 Do not switch on the handset again until it is completely dry.
W
hen it has fully dried out, you will usually be able to use it again.
Authorisation
This device is intended for analogue phone lines outside the European Economic Area (with the exception of Switzer-
land) depending on national type approval.
Country-specific requirements have b
een taken into consideration.
We, Gigaset Communications GmbH, declare that this device meets th
e essential requirements and other relevant reg-
ulations laid down in Directive 1999/5/EC.
A copy of the Declaration of Conformity is av
ailable at this Internet address:
www.gigaset.com/docs
DECT standard is supported
GAP standard is supported
Range up to 300 m outdoors, up to 50 m indoors
Base station power supply 230 V ~/50 Hz
Environmental conditions in operation +5 °C to +45 °C, 20% to 75% relative humidity
Problem Cause Solution
Nothing appears on
th
e di
splay.
The handset is not switched on.
The batteries are flat.
Press the end call key a for approx. 5 seconds or place
the handset in the base station.
Charge or replace the batteries.
No wireless connec-
tion to the base sta-
tion, Ba
se fla
shes in
the display.
The handset is outside the range of
the ba
se station.
T
he base station is not turned on.
Move the handset closer to the base station.
Check the mains connector on the base station
¢ page 4.
The display shows
Regist
er HS or Put
into base.
Handset has not been registered
w
ith the base station or has been
de-registered.
Register the handset
¢ page 12.
Handset does not
ring
.
The ring tone is deactivated.
The phone only rings if the phone
numbe
r has been transferred.
The phone does not ring in a spe-
cific time period.
Activate the ring tone
¢ page 15.
Activate the ring tone for anonymous calls
¢ page 14.
Deactivate the "Time Control" or change the time period
¢ page 14.
You cannot hear a
ringe
r/dialling tone
from the fixed line
network.
The phone cord supplied has not
bee
n used or has been replaced by
a new cord with the wrong jack
connections.
Please always use the phone cord supplied or ensure
th
at the pin connections are correct when purchasing
from a r
etailer: 3-4 assignment of telephone leads/
EURO CTR37.
Error tone sounds
af
ter system PIN
prompt.
PIN forgotten.
The system PIN you have entered is
in
correct.
Reset the system PIN to the default 0000 ¢ page 15.
All handsets are de-registered. All settings are reset.
All lists a
re deleted.
!
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gigaset A410 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gigaset A410 in the language / languages: English as an attachment in your email.

The manual is 0,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info