534703
243
Zoom out
Zoom in
Previous page
1/256
Next page
X400 3D-Printer Manual
Seite 243 /
Revision 367
Stand 08.01.201414:30
Kapitel 5. Calibration
© German RepRap GmbH 243 /
Abbildung 5.6. Repetier-Host printer configuration
The printer defines the home position through the signal from the end-stop. This defines the physical printing
limits for the respective axis. The limit at the opposite end is only defined through the software settings.
Before moving the head to the home position double check the cabling Richtigkeit der Verkabelung[S.193],
as well as the end stops. Also move the print head to a central position on all axes to avoid hitting any object
during this startup.
In case the printer head doesn't stop properly please turn off the power to the printer
immediately. Then power it back on again and re-connect from the Repetier host.
While the potentiometers are still roughly in their middle position (Befestigung Pololus[S.160]), you can click
on the Home keys in the manual control, one after the other. Once all axes are in their home position the driver
currents can be adjusted via the potentiometers.
Abbildung 5.7. Adjusting Pololu potentiometer
243


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for German RepRap X400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of German RepRap X400 in the language / languages: English as an attachment in your email.

The manual is 43,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info