797663
5
Zoom out
Zoom in
Previous page
1/76
Next page
5
because water proximity presents risk, even if the device is turned off.
20. Never use this device close to water, e.g.: Under shower, in bathtub, or above sink
filled with water.
21. If the device utilises a power adaptor, do not cover it, because this can cause a
dangerous temperature rise and can damage the device. Always connect the power
adaptor cable to the device, and then connect the power adaptor to the power socket.
22. The cutting scissors are very sharp. Use caution when assembling, dismantling and
cleaning. Do not touch any elements of the moving blade during the operation!
23.DO NOT CHARGE THE BATTERY FOR LONGER THAN 48 HOURS – this can cause
irreversible damage to the battery.
16. Do not allow the device or power adaptor to wet. If the device falls into water,
immediately remove the power plug or power adaptor from the socket. If the device is
powered, do not put hands in the water. Have the device checked by the qualified
electrician before using it again.
18. The device has to be turned off after every use.
15.If using the device in bathroom after use remove the power plug from the socket,
17. Do not touch the device or power adaptor with wet hands.
14.In order to provide additional protection, it is recommended to install residue current
device (RCD) in the power circuit, with residual current rating not more than 30 mA.
Contact professional electrician in this matter.
19. Do not leave switched on equipment or adapter without supervision.
To begin charging plug the power cord into the charging Socket (6), and the charger into a 220-240V~ 50/60Hz mains power outlet.
The charging time is about 2 hours. After that the product is full charged, the running time is about 210 minutes.
24. The charging process should be conducted in temperatures between 5-35 degrees
Celsius.
After the battery is fully charged , there will be a “beep” and the battery capacity reminder (5c) will show 100% and the charging light
(5d)will blink at the same time.
PRODUCT DESCRIPTION:
5. LCD Display 5a. Oil Indicator 5b. Speed Indicator 5c. Battery Remaining Capacity 5d. Charge Indicator
25.Do not wash the blades in water.
1. Blade Head 2. Cutting Length Switch 3. Speed button 4. Power Button / Safety Lock
26.Only change comb attachments when the device is switched off.
6 Charging Socket 7. Combs 7a. Cleaning Brush 7b. Oil bottle 7c. Cape
CHARGING THE BATTERY:
When plug the power adapter into the socket, there will be a “beep” and the charging indicator (5d) will start blinking from bottom to
top.
Note: When it runs out of battery, you can use it while charging.
When the battery reaches 10%, 5% 0%, it will beep 3 times. When the battery reduces to 5%, the charging indicator (5d) will start
blink
Motor speed range : 5 speed levels are available 5000-7000 RPM
Every time you press “+” or “-“ button (3), it will adjust 500 RPM (5b)
POWER BUTTON / SAFETY LOCK (4)
Press the power button (4) to turn it on or off
SPEED CONTROL BUTTON (3) Speed Indicator (5b)
Press and hold the power button (4) for 3 seconds, to turn the safety lock on or off
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gerlach GL 2829 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gerlach GL 2829 in the language / languages: All languages as an attachment in your email.

The manual is 5.24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info