use of the product.
2. The product can be only repaired by a licensed and trained technician.
Do not disassemble or repair the product.
3. Do not open the product case, change the equipment, replace parts or
use non-original parts (including flash drive, AV cable, etc.) as this will
void the warranty!
4. The product has a warranty label. If the label is damaged, the warranty
will be voided!
5. Do not expose the product to direct sun light, high temperature, rain or
humid and contamination environment.
6. Do not to spill any liquid on the product or leave the product in any liquid.
7. Do not use any volatile solvent for cleaning.
8. Do not adjust the product while driving.
9. When the product is plugged in, do not touch the product with wet hands.
10. If any of following situations occurs, immediately remove the power
plug and send the product back to the original retail store for repair:
– Power cable or power plug is damaged.
– Liquid gets inside the product.
– The product is dropped or the product case is damaged.
– The product cannot be started normally or a fault occurs after startup.
• Attention
1. For best performance, keep the product in the horizontal position.
2. Follow the instructions regarding indicator lights to operate the product.
3. If the cigarette lighter jack in your car is powered continuously even with
the engine is off, always disconnect the power cable from the cigarette
lighter jack before leaving your car, to avoid using up the car battery.
4. Make a backup copy for all important driving records.
5. Disconnect the power before removing the flash drive and wait until all
lights are off to remove the flash drive.
6. Any serious impact may cause loss of recording.
7. If the product comes with the GPS function:
If the memory space has only 10% of memory space remaining, the
device will beep two sounds.
The device will continuously beep when memory is full.
Use the DVR-GPS300D application to release the memory space in Micro
PD.
8.
