502912

General Electric Side by Side 25 Manual

15
Zoom out
Zoom in
Previous page
1/280
Next page
A newly-installed refrigerator may take 12 to 24 hours to begin making ice.
Automatic Icemaker
The icemaker will produce seven cubes
per cycle–approximately 100–130 cubes
in a 24-hour period, depending on freezer
compartment temperature, room temperature,
number of door openings and other use
conditions.
To access the icemaker: Pull the shelf above
the ice drawer straight out. Always be sure
to replace the shelf.
If the refrigerator is operated before the water
connection is made to the icemaker, set the
power switch in the O position.
When the refrigerator has been connected
to the water supply, set the power switch
to the l position.
You will hear a buzzing sound each time
the icemaker fills with water.
The icemaker will fill with water when it cools
to – 10°C. A newly-installed refrigerator may take
12 to 24 hours to begin making ice cubes.
Throw away the first few batches of ice to allow
the water line to clear.
Be sure nothing interferes with the sweep
of the feeler arm.
When the bin fills to the level of the feeler arm,
the icemaker will stop producing ice. It is normal
for several cubes to be joined together. If ice is
not used frequently, old ice cubes will become
cloudy, taste stale and shrink.
If ice cubes get stuck in the icemaker, the green
power light will blink. To correct this, set the
power switch to O and remove the cubes.
Set the power switch to I to restart the icemaker.
After the icemaker has been turned on again,
there will be a delay of about 45 minutes before
the icemaker resumes operation.
NOTE: In homes with lower-than-average water
pressure, you may hear the icemaker cycle
multiple times when making one batch of ice.
WARNING:Connect to potable
water supply only. Installation of the icemaker
must be done by a qualified service technician.
Special note about ClimateKeeper2
™
dispenser
models:
Dispenser models have a tilt-out ice bin.
The bin can be tilted out as shown in
the illustrations, and it will hold itself up while
you take ice out or turn the icemaker power
switch on and off. Be sure to put the bin back
in place before closing the door.
To restore your ice level from an empty bucket
stage, the following steps ar
e recommended:
12 hours after the first batch of ice has fallen
into the bin, dispense 3 to 4 cubes.
After an additional 6 hours, dispense 3 to 4
cubes again.
These steps will restore your ice level
in the shortest amount of time.
Pull the upper freezer shelf straight
out to access the icemaker. Always
be sure to replace the shelf. The
shelf can be used for storage.
NOTE: In 25BIS Models, the ice bin
is suitable for the storage of ice
only.
Icemaker
Feeler Arm
Power
Switch
Green
Power Light
Ice Drawer
Shelf
Lift the bin, then pull it forward until the bin stops.
Lower the bin to access ice or reach the power
switch.
NOTE: In order to take full advantage of the tilt-out ice bin,
only store items on the shelf below the ice bin that are no
taller than the lowest point on the bin.
On dispenser models with a tilt-out ice bin, to
access ice or reach the power switch:
Ice Storage Drawer
To access ice, pull the drawer forward.
To remove:
Set the icemaker power switch to the O (off)
position. Pull the drawer straight out and
then lift past the stop position.
To replace:
When replacing the drawer, be sure to press
it firmly into place. If it does not go all the way
back, remove it and rotate the drive mechanism
1/4 turn. Then push the drawer back again.
Ice Drawer
About the automatic icemaker.
Rotate
Drive
Mechanism
15
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for General Electric Side by Side 25 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of General Electric Side by Side 25 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 7,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of General Electric Side by Side 25

General Electric Side by Side 25 User Manual - Dutch - 15 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info