505295

General Electric GSG 25 Manual

16
Zoom out
Zoom in
Previous page
1/72
Next page
CONNECT THE TUBING TO THE
REFRIGERATOR
1
Installation Instructions
INSTALLING THE WATER LINE (CONT.)
NOTES:
• Before making the connection to the refrigerator,
be sure the refrigerator power cord is not
plugged into the wall outlet.
• We recommend installing a water filter if your
water supply has sand or particles that could clog
the screen of the refrigerator’s water valve. Install
it in the water line near the refrigerator.
Typical
Compression
Nut
Tubing
Clamp
Tubing
Ferrule
(sleeve)
Refrigerator
Connection
Reattach the access cover.
Set the icemaker power switch to the l position. The
icemaker will not begin to operate until it reaches
its operating temperature of –9°C or below. It will
then begin operation automatically if the icemaker
power switch is in the l position.
NOTE: In lower water pressure conditions, the
water valve may turn on up to 3 times to deliver
enough water to the icemaker.
START THE ICEMAKER
3
Power
switch
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the
wall. Push the refrigerator back to the wall.
TURN THE WATER ON AND PLUG
IN THE REFRIGERATOR
2
16
Place the compression nut and ferrule (sleeve) onto
the end of the tubing as shown.
Insert the end of the tubing into the water valve
connection as far as possible. While holding the
tubing, tighten the fitting.
Fasten the tubing into the clamp provided to hold
it in a vertical position. You may need to pry open
the clamp.
On models using the
refrigeration connection at
the water valve, remove the
plastic flexible cap.
Some models have the refrigerator connection at
the end of tubing located outside the compressor
compartment access cover. On other models, the
compressor compartment access cover must be
removed in order to access the refrigerator connection
at the water valve.
Tubing
Tubing Clamp
Typical
Compression Nut
Ferrule
(sleeve)
Refrigerator Connection
The illustration below or at right will look like the
connection on your icemaker.
CONNECT THE TUBING TO THE
REFRIGERATOR
(CONT.)
1
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for General Electric GSG 25 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of General Electric GSG 25 in the language / languages: English as an attachment in your email.

The manual is 1,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info