646570

General Electric GFDS175 Manual

8
Zoom out
Zoom in
Previous page
1/44
Next page
As a general rule, if clothes are sorted properly
for the washer, they are sorted properly for the
dryer. Try also to sort items according to size.
For example, do not dry a sheet with socks or
other small items.
Do not add fabric softener sheets once the
load has become warm. They may cause fabric
softener stains. Bounce
®
Fabric Conditioner
Dryer Sheets have been approved for use in
this dryer when used in accordance with the
manufacturer’s instructions.
Do not overload. This wastes energy and
causes wrinkling.
Sorting and Loading Hints
8
Using the dryer.
The Lint Filter: Clean the lint filter before
each use.
Pull out the lint filter. Moisten your fingers
and remove the captured lint. Once clean,
slide the filter back into position. Have a
qualified technician vacuum the lint from the
dryer once a year.
NEVER OPERATE THE DRYER WITHOUT ITS
FILTER IN PLACE.
Stainless Steel: To clean stainless steel
surfaces use a damp cloth with a mild, non-
abrasive cleaner suitable for stainless steel
surfaces. Remove the cleaner residue and
then dry with a clean cloth.
The stainless steel used to make the dryer
drum provides the highest reliability available
in a GE Appliances dryer. If the dryer drum
should be scratched or dented during normal
use, the drum will not rust or corrode. These
surface blemishes will not affect the function
or durability of the drum.
The Exterior: Wipe or dust any spills or
washing compounds with a damp cloth.
Dryer control panel and finishes may be
damaged by some laundry pretreatment
soil and stain remover products. Apply these
products away from the dryer. The fabric
may then be washed and dried normally.
Damage to your dryer caused by these
products is not covered by your warranty.
Dryer Interior and Duct: The interior of
the appliance and exhaust duct should be
cleaned once a year by qualified service
personnel.
The Exhaust Duct: Inspect and clean the
exhaust ducting at least once a year to
prevent clogging. A partially clogged exhaust
can lengthen the drying time.
The Exhaust Hood: Check with a mirror that
the inside flaps of the hood move freely when
operating. Make sure that there is no wildlife
(birds, insects, etc.) nesting inside the duct or
hood.
The drum lamp comes on automatically
when the door is opened.
Before replacing the light bulb, be sure to
unplug the dryer power cord or disconnect
the dryer at the household distribution panel
by removing the fuse or switching off the
circuit breaker. Reach above dryer opening
from inside the drum. Remove the bulb and
replace with the same size bulb.
Order replacement bulb WE4M305 on-line
at GEApplianceParts.com, by phone at
800.626.2002 during normal business hours,
or purchase appliance bulb 7C7 from your
local retailer.
Drum Lamp
Care and Cleaning of the Dryer.
Always follow the fabric manufacturer’s care label when laundering.
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for General Electric GFDS175 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of General Electric GFDS175 in the language / languages: English, Spanish as an attachment in your email.

The manual is 3,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info