503063
12
Zoom out
Zoom in
Previous page
1/136
Next page
Accessing Ice and Reaching the Power
Switch
To reach the icemaker power switch and access Ice,
open the Ice box door located on the refrigerator door
and remove the bucket.
About the automatic icemaker. GEAppliances.com
A newly installed refrigerator may take 12 to 24 hours to begin making ice.
Icemaker
Feeler Arm
Power
Switch
Green
Power Light
To access ice.
Ice Bucket
Mullion
To reach the power switch.
Icemaker Accessory Kit
If your refrigerator did not come already equipped with an automatic icemaker, an icemaker accessory kit is available at extra cost.
Check the back of the refrigerator for the specific icemaker kit needed for your model.
12
Automatic Icemaker (on some models)
The icemaker will produce seven cubes per cycle—
approximately 100–130 cubes in a 24-hour period,
depending on freezer compartment temperature, room
temperature, number of door openings and other use
conditions.
See below for how to access ice and reach the power
switch.
If the refrigerator is operated before the water
connection is made to the icemaker, set the power
switch in the O (off) position.
When the refrigerator has been connected to the water
supply, set the power switch to the l (on) position. The
icemaker power light will turn green when the freezer light
switch is pressed in or when the freezer door is closed.
The icemaker will fill with water when it cools to 15°F
(–10°C). A newly installed refrigerator may take 12 to 24
hours to begin making ice cubes.
You will hear a buzzing sound each time
the icemaker fills with water.
Throw away the first few batches of ice to allow the
water line to clear.
Be sure nothing interferes with the sweep
of the feeler arm.
When the bin fills to the level of the feeler arm, the
icemaker will stop producing ice. It is normal for several
cubes to be joined together.
If ice is not used frequently, old ice cubes will become
cloudy, taste stale and shrink.
NOTE: In homes with lower-than-average water pressure,
you may hear the icemaker cycle multiple times when
making one batch of ice.
NOTE: Set the power switch to the O (off) position if the
water supply is shut off.
(Ice & Water Models)
To access ice.
Ice Bin
Shelf
To reach the power switch.
(Single Drawer Models)
Accessing Ice and Reaching the Power
Switch
To reach the icemaker power switch, pull the shelf
above the ice bin straight out, Always be sure to replace
the shelf.
To access ice, simply pull the bin forward.
Ice Bin
Shelf
Power switch
Lift and pull
Ice Box Door
Accessing Ice and Reaching the Power
Switch (Double Drawer Models)
To reach the icemaker power switch,
open the top freezer drawer and remove the full-width
basket. Always be sure to replace the basket.
To access ice, open the bottom freezer drawer. The ice
bucket is located below the mullio. Pull it foward to
access the ice.
Ice Bucket and Dispenser
• Pull up and out on the ice bucket to remove it from the compartment .
• To replace the ice bucket, set it on the guide brackets and push until
the ice bucket seats properly.
• If bucket cannot be replaced, rotate the Ice Bucket Fork 1/4 turn
clockwise.
Extra Ice Storage
• There is additional ice storage in the freezer compartment drawer.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for General Electric CFCP1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of General Electric CFCP1 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 5,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info