Manual Gemini XGA-2000 (page 11 of 23) (English, German, French, Spanish)

503424

Zoom out

Zoom in

1/23

ProtectLED:protectLED(20)whenyourstturnonthe

amplier, the protect LED light briey during a turn-on

delay which indicates that the outputs are disconnected

internally. There will be an audible click when the outputs

reconnect and the protect LED (20) will turn off. Otherwise,

the protect LED (20) indicates that there is a problem ei-

therintheamplier’sexternalconnections,loadortem-

perature conditions or its internal functions. If one of these

situationsoccur,theampliersensestheproblemandau-

tomatically switches into protection mode. The LED will

lighttowarnyouofthetroubleandtheamplierwillstop

working.Ifthisoccurs,switchofftheamplierandreferto

the trouble shooting guide. If the protect LED (20) remains

litwhenresumingamplieroperation,donotusetheam-

plierandcontactanauthorizedservicetechnician.

LEDdeprotección:ElLEDdeprotección(20)laprimera

vezqueenciendeelamplicador,seiluminabrevemente

durante el transcurso de la conexión lo cual indica que

lassalidasestándesconectadasinternamente.Habráun

clic audible cuando las salidas se reconecten y el LED de

protección(20)seapagará.PorotraparteelLEDdepro-

tecciónLED(20)indicaquehayunproblemayaseadelas

conexiones externas del amplicador, carga o tempera-

tura o sus funciones internas. Si una de esas situaciones

seproduce,elamplicadordetectaelproblemaycambia

automáticamenteamododeprotección.ElLEDseilumi-

nará para avisar de los problemas y el amplicador de-

jarádefuncionar.Siocurreesto,apagueelamplicador

y consulte la guía de solución de problemas. Si el LED

de protección permanece encendido cuando reanude la

operaciónconelamplicador,noutiliceelamplicadory

contacteconelserviciotécnicoautorizado.

LED de protection: les LEDs de protection (20)

s’allumerontdèslamise sous tensionde l’amplicateur,

puis s’éteindront progressivement indiquantune décon-

nexion interne des sorties HP. Il y aura alors un clic au-

dibleetlesLEDsdeprotection(20)s’éteindront.LesLEDs

deprotection(20)  serventaussi à indiquerun dysfonc-

tionnement interne (Surcharge, surchauffe…) ou externe

(Branchements enceintes). Si l’une de ces situations se

produit, l’amplicateur se mettra automatiquement en

modeprotection.LesLEDsvousavertirontdelaprésence

d’unproblème&l’amplicateurcesseraalorsdefonction-

ner. Veuillez alors consulter le guide des dysfonctionne-

ments. Si les LEDs de protection (20) restent allumées

après avoir éteint puis rallumer l’amplicateur, n’utilisez

plus ce dernier & veuillez contacter votre revendeur ou le

servicetechniquedeGCITechnologies.

Protect LED: Wenn Sie Ihren Verstärker einschalten

leuchtet die Protect LED (20) während des Einschaltvor-

gangs und zeigt damit, dass die Lautsprecheranschlüsse

noch intern getrennt sind. Sie Hören ein Klicken sobald

die Lautsprecheranschlüsse wieder verbunden werden

und die Protect LED geht aus. Außerdem zeigt die Protect-

LED an, wenn Probleme mit der externen Beschaltung, der

Belastung, Temperatur oder interne Fehlfunktionen auf-

treten. Sollte eines dieser Probleme auftreten, so schaltet

der Verstärker automatisch in den Protection-Modus.

Die LED leuchtet auf und zeigt Ihnen damit die Störung

anund derVerstärker stellt die Funktion ein. Sollte dies

eintreten schalten Sie den Verstärker aus und schauen

Sie unter “Fehlerbeseitigung” nach. Sollte die Protect

LED (20) nach einem erneuten Einschalten weiterhin

leuchten, so belassen Sie ihn ausgeschaltet und nehmen

Sie Kontakt zu einem autorisierten Servicetechniker auf.

Levelcontrols:level controls (21, 22) establish theinput

levelsrequiredforeachchannel.Onlythechannel1level

control (20) works in mono bridge mode.

Controldeniveles:Loscontrolesdeniveles(21,22)esta-

blecen la entrada de niveles requeridaparacada canal.

Sólo el canal 1 control de nivel (21) funciona en modo

mono puente.

Potentiomètresdevolume:lespotentiomètresdevolume

(21,22)permettentderéglerleniveaud’entréeparcanal.

En mode bridge, seul le potentiomètre 1 (21) fonctionne.

Lautstärkeregler:MitdenLautstärkereglern(21,22)stel-

lenSiediegewünschteEingangslautstärkefürjedenKanal

ein. Im Modus “mono-gebrückt” arbeiten Sie nur mit dem

Regler von Kanal 1 (21).

Theamplier’spowermustbeturnedoffwhenchanging

modes of operation.

Elamplicadordepotenciadebeestarapagadoalcam-

biar los modos de funcionamiento.

Lorsque vous souhaitez modier le mode de fonction-

nement de l’amplicateur, celui-ci doit impérativement

êtreéteint.

DerVerstärkermussausgeschaltetsein,bevorSieden

Betriebsmodus umschalten.

The unit has two channels for stereo operation. Each chan-

nel provides a separate and discrete signal at the speaker

outputs according to the signal received at the inputs. The

following instructions are for applications with 8 ohm and

4 ohm speakers of matched power ratings.

La unidad tiene dos canales para estéreo. Proporciona

un canal independiente y señal en las salidas de los alta-

voces de acuerdo a la señal recibida en las entradas. Las

siguientes instrucciones son para aplicaciones con alta-

vocesde8ohmy4ohmqueseajustenalasespecica-

cionesdepotenciadelamplicador.

L’amplicateurpossède2canauxpourunfonctionnement

stéréo. Chaque canal fournit un signal séparé &discret

auxenceintesconnectéesàl’amplicateurdépendantdu

signalaudiostéréoreçuenentrée.Lesinstructionssuiv-

antes concernent les applications sous 8 - 4 Ohms & les

puissancesinhérentes.

Das Gerät hat zwei Kanäle, um stereo betrieben zu

werden. Jeder Kanal verfügt über ein separates Signal

amLautsprecherausgang,welches ein Ebenbild desjew

Connections and System Control

ConexionesyControldesistema•Connexions&Utilisation•AnschlüsseundSystemeinstellungen

Operatinginstructions•Instruccionesdefuncionamiento

Instructionsdefonctionnement•Bedienhinweise

Stereooperation•Estéreo

ModeStéréo•StereoBetrieb

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Gemini XGA-2000 in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 2,15 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Gemini XGA-2000 Manual

Product: