479850
2
Zoom out
Zoom in
Previous page
1/5
Next page
DESCRIPTION
Gemini 7057
Gemini 7057 is a compact, self-powered alarm with sensors and siren. Studied for vehicles
equipped with original transmitter and direction indicator lights flashing while opening and
closing the vehicles door.
Gemini 7056
As Gemini 7057 without self-power and engine immobilisation.
FUNCTIONS
- Control for alarm arming/disarming through the direction indicators lights and controls for the
vehicles lock actuators.
- Blinker and electronic siren.
- Perimetrical protection and volumetric protection only for Kit 7057US and Kit 7056US.
- Positive and negative control for vehicles equipped with “Pack-comfort” system.
- Engine immobilisation (only 7057).
- Negative control external additional siren.
- Automatic arming.
- Absorption sensor.
- LED’s memory.
The alarm system is supplied with two mechanical keys for the emergency release.
INSTALLATION INSTRUCTIONS (for the installer).
- It is necessary to memorise the arming/disarming sequence controls through the direction indicator
lights after the wiring connections.
- The alarm wiring harness must be positioned away from the vehicle high voltage wires in order to
avoid interference which could generate wrong working of the system.
- On vehicles with catalytic converter, the engine immobilisation must be carried out on the fuel
pump.
- For systems with volumetric sensors (art. 7057US e 7056US), the transducers must be installed at
the top of each windscreen pillar, far from the ventilation or the conditioning air outputs.
- Note : to obtain the correct working of the automatic arming and perimetrical protection functions,
connect the GREEN -BROWN wire to the boot/door switches.
DIP SWITCHES PROGRAMMING TABLE
1 ON Current absorption sensor ON
1 OFF Current absorption sensor OFF
2 ON Passive arming ON
2 OFF Passive arming OFF
3 ON Arming/disarming acoustic signalling OFF
3 OFF Arming/disarming acoustic signalling ON
4 ON Arming/disarming control through the direction indicator lights and the
vehicle lock actuators.
4 OFF Arming/disarming control through the direction indicator lights.
ATTENTION: SELECT THE DIP-SWITCHES BEFORE TURNING THE EMERGENCY KEY TO ON.
ACCORDING TO THE RULES POSITION THE DIP-SWITCH N.1 TO OFF.
WIRING CONNECTIONS
(DISCONNECT THE NEGATIVE TERMINAL OF THE BATTERY AND ONLY RE-CONNECT AFTER THE
INSTALLATION IS COMPLETE)
FUNCTIONS WIRE COLOURS
Earth êê BLACK initialled M
Battery positive terminal êê BLACK initialled R
Engine immobilisation êê 2x GREY initialled H
Ignition live êê YELLOW
Door pin switch êê GREEN-BROWN
Boot/bonnet pin switch êê BLACK initialled V
Positive alarm armed êê PINK
Sensors inlet êê GREEN-BLACK
Negative comfort control additional siren êê YELLOW-BLACK
Positive Comfort control êê RED-BLACK
Negative Comfort control êê WHITE-BLACK
Arming/disarming control through the direction
indicator lights + Blinker.
êê 2 x ORANGE
Arming Synchronism control êê YELLOW-BLUE
Disarming Synchronism control êê GREEN-BLUE
NOTE: connect always the synchronism controls (YELLOW-BLUE and GREEN-BLUE wires) to
the two polarity reversal wires of the L.H.S. actuators lock.
The wiring harness is supplied with two connectors; connect the 4 pin connectors to the ultrasonic
module and the two pin connector to the LED.
SELF-LEARNING FUNCTION OF THE DIRECTION INDICATOR LIGHTS
FLASHING SEQUENCES.
IMPORTANT: BEFORE ACTIVATING THE SELF-LEARNING FUNCTION, IT IS NECESSARY TO SELECT
CORRECTLY THE DIP-SWITCHES AND TO CARRY OUT THE WIRING CONNECTIONS. DO NOT USE THE
TRANSMITTER BEFORE HAVING ACTIVATED THE SELF-LEARNING FUNCTION.
THIS FUNCTION ALLOWS MEMORISING THE SEQUENCE OF THE DIRECTION INDICATOR LIGHTS
FLAHING WHILE OPENING OR CLOSING THE DOOR.
To activate the self-learning function proceed as follows:
- Position the alarm key to OFF.
- Turn the ignition key to ON.
- Position the alarm key to ON.
- The LED of the alarm lights.
- Turn the ignition key to OFF.
- Close the vehicle door with the original transmitter. The LED stops lightning at the first
direction indicator lights flashing. One audible tone signals the door closure.
Note: wait always till the audible tone before learning the door opening.
- Open the vehicle door with the original transmitter. The LED stops lightning at the first
direction indicator lights flashing. Two audible tones signal the end of the self-learning
operation of the 7057 or 7056 system.
THE ACOUSTIC SIGNALLING CAN BE OBTAINED ALSO WITH THE DIP-SWITCH
N. 3 TO ON.
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gemini 7057 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gemini 7057 in the language / languages: English as an attachment in your email.

The manual is 0,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info