749313
12
Zoom out
Zoom in
Previous page
1/92
Next page
12
lights up, and the operating mode (Ready) and current time are shown in the LED display.
(See section C for setting the current time)
Any paper in the feeder is detected automatically and the device starts operating; the oper-
ating mode (In Use) and the current time are shown in the LCD display. Once all paper has
been shredded and no additional paper is fed into the machine, the device stops automati-
cally (Standby Mode).
An automatic reverse and stop function prevents a paper jam when the device is
overloaded with too much paper in the feeder. Should a paper jam occur, remove all paper
from the feeder and wait until the device has finished its automatic cleaning process and has
stopped operating. Only insert a maximum of 12 sheets A4, 70 g/m² into the feeder.
‘FWD‘ If you place a narrow piece of paper (< 10 cm) into the feeder sideways, then the pho-
toelectric barrier may not detect it and thus not start the device automatically. In this
case, press and hold the button ‘FWD‘ until the paper has been drawn in completely.
‘REV‘ By pressing the button ‘REV‘, you can initiate the reverse operation of the cutting
mechanism in case of a paper jam.
When the sensor detects that the waste paper container is full, the device stops automati-
cally and the red LED ‘Bin Full‘ lights up, and the LCD display will show ‘Basket Full‘. First
remove all paper from the feeder, and then empty the waste paper container. Please note the
instructions in the section: ‘Maintenance‘
B. Feeding CDs/DVDs, Credit Cards and Floppy Disks into the Shredder
This device is equipped with a separate cutting mechanism for CDs/DVDs, credit cards and
floppy disks. If you would like to utilise this function, proceed as follows:
1. Switch on the file shredder by pressing the power button on the rear of the device. The
green LED ‘Power‘ lights up, and the operating mode (Ready) and current time are shown
in the LED display. (See section C for setting the current time)
2. Any CDs/DVDs, credit cards and floppy disks in the CD slot are detected automatically,
the device starts up and the operating mode ‘In Use‘ is shown on the LCD display.
CDs/DVDs, credit cards and floppy disks are shredded into 10 mm wide strips. Make sure to
keep your face well away from the feeder slot when shredding CDs/DVDs, since these types
of material always pose a hazard of splintering!
The shredded material is collected in a separate waste receptacle to facilitate environmen-
tally friendly disposal.
C. Setting the Current Time
Press the button ‘Setup‘ once. By pressing the button ‘FWD‘, you can now increase the hour
displayed, and by pressing the button ‘REV‘ you can decrease the hour displayed.
Press the button ‘Setup‘ twice. By pressing the button ‘FWD‘, you can now increase the min-
utes displayed, and by pressing the button ‘REV‘ you can decrease the minutes displayed.
Important note:
The device will switch off automatically if the motor temperature increases too much. The
red LED ‘Overheat‘ lights up and signals that the overheat protection of the device has been
activated - the LCD display shows ‘Please Wait‘. If that is the case, the device will not react
when you press the button ‘REV‘ or ‘FWD‘. The device switches back into normaloperation
as soon as the motor has cooled sufficiently.
Manual_Office_X12CDindd.indd 12 15.07.10 15:39
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Geha Office X12 CD Shredder at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Geha Office X12 CD Shredder in the language / languages: English, German, Dutch, French, Italian, Polish, Swedish, Turkish, Spanish as an attachment in your email.

The manual is 6,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info