3 4
Improving Sound by Switching Channels
The CL7350 can transmi t on either of two built-in
frequency channels. Y ou can sele ct the channel that
will produce better audio quality .
1. If the audio sound is distorted or unclear, press th e
Auto Tune Bu tton on the TV Receiver (se e figure (7)),
to match the frequency of Channel 1 or Channel 2
set at the bac k of Transmitter. Allow a few seconds
for the audio t o resume.
2. If this does not help, switch the channel selector on
the rear of the Charging Cradle (see figure (8)) and
see if the audio qu ality has improved.
3. Press the Auto T une button again to improve th e
quality still further .
NOTE: The T ransmitter will turn of f automatically after
about 5 minutes if the re is no audio signal from th e audio
source (TV set, etc.), or the signal from the audio source
is too weak f or proper reception. Howe ver , if the audi o
signal returns to an acce ptable level, the tran smission
will automatically restart.
Controlling the T one (Bass & T reble)
You can adjust the tone of the audio you are listening to and enh ance your listening
pleasure by amplifying either the
Treble or the Bass in the Headset
Receiver.
Press the Tone Clarity Button
to switch cyclically between :
1.Enhanced treble (ye llow LED glows
),
2.Enhanced bass (blue LED glows
), or
3.Flat tone (bass an d treble equally
enhanced, no LEDs glo wing
).
Adjusting the Sound Balance (lef t-right)
Y ou can adjust the sound to suit you r hearing in each ear .
With the Receiver on, rotate the Sound Balance button
(see figure (10)) to adjust the sound – you will notice
that the sound seems to “drif t” from one side to the
other . Play with this button until you find your most
pleasant sound balance.
Using the Mic Button and Microphone for
Conversation
Y ou can switch from Listening mode to Conversation
mode without having to take off the Receiver .
T o talk or listen to someone:
1. Press the Mic button (see figure (1 1)). This will shut
off the Audio Source and the Receiver will beco me an
amplifier by activa ting the Micropho ne.
2. T o resume listening to your audio device, press the
Mic button again . The microphone will be shut o ff and
the audio will resume .
Charging the Battery
1. The signal LE D Indicator on the Head set Receiver will
blink slowly when th e battery level is low. At thi s stage
there are about 20 minu tes of operating time before
the Headset will switch off. Recharge the battery.
2. Switch OFF the On/Off Switch on the Headset (see
figure (12)). The green LED on the Headset should
turn off.
3. Place the Headphone on the Cha rging Cradle (see
figure (13)), make sure the charge contact touches
the charge pins on the Chargin g Cradle.
4. The Charging process st arts automatically.
• The LED Indicator glows red durin g charging.
• It will glow in green after the battery is fully charged.
W ARNING: The battery must not be exposed to
excessive heat such as sunshine, fire etc.
Do not attempt to replace the original rechargeable
battery .
When the head phones are not in use, m ove the switch to the OFF position to av oid
damaging the batteries.
The battery must a lways be fully charged before first use. An initia l 3 hours charge is
required to guarantee an acceptable service life for the rechargeable battery . Always
ensure that the Receiver is switched to OFF position while the battery is charging.
Excessive sound pressure from earphones and headphones can cause hearing loss.
IMPORT ANT :
This unit should be operated with built-in rechargeable battery only . When replacing
the battery or when disposing of the unit, always comply with applicable laws relating
to the disposal of battery . Please place them in a proper disposal container to ensure
that they are eliminated safely and in an environmentally friendly way .
TECHNICAL SPECIFICA TIONS
Battery operating Time : Up to 6 Hours
Range : between 10 to 25 meters
Frequency response : 30 Hz – 10K Hz
Signal-to-noise ratio : >65 dB
Distortion : <2%
Headset weight : 50 grams
Operating voltage : Charging Cradle: 8V, 400mA
: Headset: 3.7V, 350mA Lithium Polymer Battery
Transmission mode : UHF Stereo
Carrier frequency : 863 MHz (CL7350 OPTICLIP VDE&UK version)
: 900 MHz (CL7350 OPTICLIP US version)
TROUBLESHOOTING
No Sound
• Ensure the power supply is properly plugged into the electricity socket and that its
cable is properly connected to the DC IN connector on the Charge Cradle.
• Ensure that the Headset Po wer ON/OFF switch is switched ON.
• Check the state of the Battery charging in the Headset – place it in the Charge
Cradle and recharge the batter y until the Battery Charge LED turns g reen.
• Ensure that the TV set, Hi-Fi syste m or audio component is switched ON and set to
a channel that broadcasts an audio signal.
• Ensure that the volume on the connected audio component is turned up to at least
half its full vo lume.
• The connected audio/video equipmen t may not be in playbac k mode. Start
playback on by the equipment.
• Use the Volume Control on the Headset to turn up the vo lume.
• Check whether the Headset volume level is set too low. Adjus t the volume to a
suitable level.
• If the sound is not clear an d distorted, change the frequency Chan nel selection on
the back of the Charge Cradle, and then press the Auto Tune Button on the
Headset Receiver for better reception .
Distortion
• The battery inside Headset may need charging. Re charge the battery.
• The Headset may be too far away from the transmitter inside the Charge Cradl e.
Bring them closer together.
• The audio signal input level from the au dio source is too low. Increase the volume
at the audio source.
• If the sound is not clear and distorted, change the frequency Channel on the back
of the Charge Cradle, and then press the Auto Tune Button on the Headset for
better reception.
.
Cleaning & Maintenance
Note: DO NOT use alcohol, chemical or spirit based cleaning agent s.
Wipe Base and Headset cl ean with a damp cloth.
GUARANTEE
From the moment your Ge emarc product is purchased, Geemarc guarantee it for the
period of two years. During this time, all repairs or replacements (at our discretion) are
free of charge. Should you experience a problem then contact our help line or visit our
website at www.geemarc.com .
The guarantee does not cover accidents, negligence or breakages to any part s. The
product must not be tampered with or taken apart by anyone who is not an au thorized
Geemarc representative.
The Geemarc guarantee in no way limit s your legal rights.
IMPORT ANT : YOUR RECEIPT IS P ART OF YOUR GUARANTEE AND MUST BE
RET AINED AN D PRODUCED IN THE EVENT OF A WARRANTY CLAIM.
Please note: The guarantee applies to the United Kingdom onl y .
DECLARA TIONS
CE Directives
Geemarc T elecom SA hereby declares that this product is in compliance
with the essential requirement s and other relevant provision s of the Radio and
T elecommunication s T erminal Equipment Directive 2014/53/UE.
The CE declaration of conformity m ay be consulted at www .geemarc.com
FCC NOTICE
This device complies with p art 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
FCC CAUTION
Any changes or modifica tions not expressly approved by the party responsible for
compliance could void th e user ’s authority to operate this equipment. This device and
its ant enna(s) must not be co-located or oper ating in conjunct ion with any other ant enna
or transmitter .
Electrical connection: The apparatus is des igned to op erate from a 230V 5 0Hz
supply only . (Classified as hazardous voltage according to EN60950 standard). The
apparatus does not incorporate an integral power on/o ff switch. T o switch off the
apparatus, disconnect the power adap tor .
When inst alling the app aratus, ensure th at the mains power so cket is readily accessible.
Recycling Directives
The WEEE (W aste Electrical and Electronic Equipme nt) has been put in place
for the products at the end of their useful life are recycled in the best way .
When this product is finished with, please do not put it in your domesti c waste bin.
Please use one of the following disposal options:
- Remove the batteries and deposit them in an appropriate WEEE skip.
Deposit the product in an appropriate WEEE skip.
- Or , hand the old product to the retailer . If you purchase a new one, they should
accept it.
Thus if you respect these instructions you ensure hu man health and environmental
protection.
For product support and help visit our website at www. geem arc. com
Contact Ge emarc UK:
5B Swallow Court, Swallowfields, Welwyn Garden City , Hertfordshire, AL7 1SB,UK
telephone 01707 38760 2
or fax 01707 832529
QUGCL7350 OPTICLIP_En_A3_V1.2
MIC
Button
Microphone