Description of the appliance
The TCS-Cody consists of a decoder and a keyboard. The units are connected by a simple
double-wire cable without a special plug. Programming of the TCS-Cody is possible with the
keyboard and the master code.
Master code:
The master code is an 8-digit numeral code necessary for all programming procedures.
Only after the input of this code the appliance can be programmed according to your per
sonal needs. TCS-Cody is preset by the company with the master code 12345678.
Pass code:
The pass code is either a four- or five-digit numeral code, by which you operate your door
drive unit. You have the possibility to store up to 50 different pass codes, which means
that up to 50 different persons with different pass codes can open the door. If you are
accompanied by another person when entering your pass code you can first press as many
keys as you like before you finally enter your code. This ensures that no other person can
notice your pass code, but the TCS-Cody recognizes your pass code as correct!
The TCS-Cody is preset by the company with the pass code 1234 on memory location 01.
ATTENTION!!!
After you have made yourself familiar with the functions of the appli
ance, please program your personal master code as well as a pass
code with which you replace the pass code which is located on the
memory place 01. Only by this your TCS-Cody is protected against
manipulation!
TIPTOMATIC
Especially for garage doors the TCS-Cody is designed with TIPTOMATIC-timing. After
input of a pass code and within a period of 60 seconds (adjustable) this function allows to
control the door with any key, except for the key, and without the need to enter
the pass code once again. This isolating facility can, however, be interrupted prior to
the expiration of the 60 seconds, by pressing the key.
Lock-out function:
If the lock-out function is activated the the TCS-Cody automatically blocks for 10 seconds
after the input of a wrong pass code which is signalled with a double sound signal.
By choice, you can arrange that the lock-out time can be doubled after any wrong input
until a correct pass- or master code is entered.
The end of the blocking time is signalled by a long sound signal.
Program 2
Input / Clearing of a pass code
Input 8-digit
master code
Input 4- or 5-digit
pass code
Sound
signal
2 x long
Push key
button
Push key
button
Input of 2-digit
memory location
e.g. 07 or 28
Sound signal
1 x long
Push key
button
The pass code entered is now stored at the memory
location selected and connected to the fixed output !
With this procedure you can allocate 50 different
pass codes to the memory locations 00-49 !!
2
