22087
11
Zoom out
Zoom in
Previous page
1/16
Next page
11
Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions
Before you call for service…
GEAppliances.com
Problem Possible Causes What To Do
Control panel lights go off Time too long between Each pad must be touched within 30 seconds of the others.
when you’re setting controls touching of selected pads To relight, touch any pad again, or unlock and relatch door.
Noise Some of the sounds you’ll Detergent cup opening.
hear are normal
The motor stopping during the drying period.
Water draining out of the tub immediately after you
touch START/RESET pad.
Utensils are not secure in the Make sure everything is secured in dishwasher.
rack or something small has
dropped into the rack
Motor hums Dishwasher has not been used on a regular basis. If you
do not use your dishwasher often, set it to fill and pump
out once every week. This will help keep the seal moist.
Detergent left in Dishes are blocking the Reposition the dishes.
dispenser cups detergent cups
Water standing in This is normal A small amount of clean water around the outlet on the
the bottom of the tub tub bottom at the back of the tub keeps the water seal
lubricated.
Water won’t pump Drain is clogged If you have an air gap, clean it.
out of the tub
Check to see if your kitchen sink is draining well. If not,
you may need a plumber.
If the dishwasher drains into a disposer, run disposer clear.
Suds Correct detergent wasn’t used Use only automatic dishwasher detergents to avoid sudsing.
Cascade
®
, Cascade Complete
®
and Electrasol
®
dishwasher
detergents have been approved for use in all GE dishwashers.
To remove suds from the tub, open the dishwasher and
let suds dissipate. Add 1 gallon of cold water to the tub.
Close the door until it locks into place. Pump out water by
pressing START/RESET, then after waiting 10 seconds press
START/RESET again. Repeat if necessary.
Rinse agent was spilled Always wipe up rinse agent spills immediately.
Stained tub interior Detergent with Some detergents contain colorant (pigment or dyes) that
colorant was used will discolor the tub interior with extended use. Check the
detergent cup for signs of any discoloration. If cup is
discolored, change to detergent without any colorant. Cascade
®
,
Cascade Complete
®
and Electrasol
®
Dishwashing Detergents
have been approved for use in all GE dishwashers.
Some tomato-based Use of the RINSE ONLY cycle after adding the dish to the load
foods can stain can decrease the level of staining.
Dishes and flatware Low inlet water temperature Make sure inlet water temperature is correct (see page 6).
not clean
Water pressure is temporarily low Turn on a faucet. Is water coming out more slowly than usual?
If so, wait until pressure is normal before using your dishwasher.
Air gap is clogged Clean the air gap.
Improper rack loading Make sure large dishware does not block the detergent
dispenser or the wash arms.
Troubleshooting Tips
Save time and money! Review the charts on the following pages,
or visit GEAppliances.com. You may not need to call for service.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for GE PDW7300JBB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of GE PDW7300JBB in the language / languages: English as an attachment in your email.

The manual is 1,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info